Mist Flow Visualization for Round Jets in Aerosol Jet Printing

James Q. Feng

DOI: https://doi.org/10.1080/02786826.2018.1532566

2018-10-06

Abstract:With the microdroplets of water serving as light scattering particles, the mist flow patterns of round micro-jets can be visualized using the Aerosol Jet(R) direct-write system. The visualization images show that the laminar mist jet appears to extend to more than 20 times the diameter of nozzle orifice, D, for jet Reynolds number Re < 600, especially with D = 0.3 mm and less. For smaller jets (e.g., with D = 0.15 mm), laminar collimated mist flow might be retained to 40xD for Re < 600 and for Re ~ 1500 within 20xD from the nozzle. The laminar part of mist flow associated with larger jets (e.g., with D = 1.0 mm for Re < 600) tends to exhibit noticeable gradual widening due to viscous diffusion. For free jets, their breakdown length--the distance from nozzle where transition from laminar to turbulent mist flow takes place as signaled by the inception of a rapid widening of mist stream--is shown to decrease with increasing Re. The presence of impingement wall tends to prevent turbulence development, even when the wall is placed further downstream of the free-jet breakdown length for a given Re . The critical Re for an impinging jet to develop turbulence increases as the standoff S is reduced. The mist flow of impinging jet of D = 1.0 mm seems to remain laminar even for Re > 4000 at S = 12 mm.

Fluid Dynamics