Abstract:The accidental thermal abuse of single lithium ion cells via overheating is a common cause of thermal runaway (TR). Moreover, the occurrence of TR in any single cell of a battery module composed of multiple cells can lead to catastrophic damage via TR propagation (TRP) through the module. However, few studies have evaluated the primary characteristics of thermally-induced TR and TRP in actual battery modules experimentally under open-air environments. The present study addresses this issue by establishing the temperature, smoke propagation, and combustion characteristics of enclosed pouch battery modules composed of 12 LiNi0.8Co0.1Mn0.1O2 cathode and graphite anode cells operating in a 4 parallel, 3 series configuration during the TRP process based on three parallel experiments conducted in an open-air environment with a heating plate applied to the first cell of the module to trigger TR, and temperature sensors positioned along the sequence of cells. Analysis of the TR process arising in the first cell demonstrates that an intense flame tends to be produced at the cathode because TR is initiated at the cathode. The fact that TR occurs within an enclosed module shell produces reductive gases attacking the anode, which limits the flame at the anode to a relatively small size, with a high proportion of dense smoke that flows more slowly than smoke flow at the cathode. The TR process then dramatically propagates, induces intense combustion at both the positive and negative electrode locations, and produces a maximum temperature of 1370 degrees C in the central region of the module. However, TR does not propagate uniformly in sequence from cell 1 to cell 12 within the module, but rather propagates in reverse from cell 6 to cell 5 in the middle of the module. This arises due to the influence of the flow of high-temperature smoke within the battery module enclosure during TR. Analysis of the combustion properties of the modules and the velocity profiles of flame jets demonstrate that the TRP process observed under the conditions of this study represent a high-temperature fire comprised of high-speed flame jets, which would exacerbate the propagation of TR between the adjacent cells of the battery module, and ultimately lead to extensive fire damage for the entire module or even the entire vehicle.

Experimental study on thermal runaway propagation characteristics of NCM811 lithium-ion batteries with different SOCs induced by dual heat sources

Experimental Investigation on the Thermal Runaway and Its Propagation in the Large Format Battery Module with Li(Ni1/3Co1/3Mn1/3)O-2 As Cathode

Experimental investigation of thermal runaway in 40Ah prismatic lithium batteries at different SOC

Experimental study on thermal runaway and its propagation in the large format lithium ion battery module with two electrical connection modes

An investigation on thermal runaway behaviour of a cylindrical lithium-ion battery under different states of charge based on thermal tests and a three-dimensional thermal runaway model

Experimental Study on the Thermal Runaway and Its Propagation of a Lithium-Ion Traction Battery with NCM Cathode under Thermal Abuse

A comparative analysis on thermal runaway behavior of Li (NixCoyMnz) O2 battery with different nickel contents at cell and module level

Experimental Investigation of the Thermal Runaway Propagation Characteristics and Thermal Failure Prediction Parameters of Six-Cell Lithium-Ion Battery Modules

Experimental Investigation of Thermal Runaway Characteristics of Large-Format Li(Ni0.8Co0.1Mn0.1)O2 Battery under Different Heating Powers and Areas

Thermal Runaway Propagation and Combustion Characteristics of Enclosed LiNi0.8Co0.1Mn0.1O2 Pouch Battery Modules in an Open Environment

Experimental Investigation of Thermal Runaway Propagation in a Lithium-Ion Battery Pack: Effects of State of Charge and Coolant Flow Rate

Investigation on Thermal Runaway of Li-Ion Cells Based on LiNi1/3Mn1/3Co1/3O2

Experimental and Modeling Analysis of Thermal Runaway for LiNi0.5Mn0.3Co0.2O2/Graphite Pouch Cell Triggered by Surface Heating

Experimental Study on the Effect of State of Charge on Failure Propagation Characteristics Within Battery Modules

Experimental investigation on thermal runaway propagation in the lithium ion battery modules under charging condition

Experimental investigation on thermal runaway propagation of large format lithium ion battery modules with two cathodes

Experimental study on thermal runaway of fully charged and overcharged lithium-ion batteries under adiabatic and side-heating test

The Experimental Research for Infrared Radiation Non-Contact to Trigger Cell Thermal Failure: Thermal Runaway Behavior and State of Charge Influential Analysis

Study on Thermal Runaway Propagation Characteristics of Lithium Iron Phosphate Battery Pack under Different SOCs

Experimental Study on Thermal Runaway Behavior of Lithium-Ion Battery and Analysis of Combustible Limit of Gas Production

Experimental and simulated study of thermal runaway characteristics of 16Ah nickel-cobalt-manganese (523) square soft-pack lithium-ion battery