Abstract:The flow behavior of the powder layer significantly affects subsequent dynamic behavior and final quality of the parts fabricated via powder bed-based additive manufacturing. High powder layer quality is the key scientific problem and technical difficulty, however, the dynamic flow behavior of powder particles and its relationship between powder layer quality were not well understood. In this paper, the influences of typical factors including process parameters (relative layer height and blade velocity) and powder properties (particle size and surface energy coefficient) on powder layer quality of polyamide 6 were systematically investigated by discrete element method to understand the mechanism of the powder layer packing behavior at the particle scale. The packing density, structure uniformity, normalized layer thickness, and surface uniformity were introduced to quantitatively characterize the powder layer quality. The mechanisms at the particle scale, including the blocking of particle, force arch, particle velocity distribution, and cohesion effect were discussed in detail. The results showed that a decreasing value particle size/layer height can effectively weaken the blocking effect of particles, improving the continuity and stability of powder flow and inducing a dense and uniform powder layer. The particles with high average velocity in the gap between the blade and baseplate will move forward after the blade leaves, significantly reducing the layer thickness and packing density. Meanwhile, the cohesion force was determined by the particle size and surface energy coefficient, and the cohesion effect dominated the flow behavior of the particles with a small particle size d = 10μm or a large surface energy coefficient γ = 0.2mJ/m2. These findings can provide useful guidance in understanding the flow behavior at the particle scale and improving the powder layer quality.

Compatibility of tool geometry and process parameters in powder bed fusion

Effect of blade geometry on the powder spreading process in additive manufacturing

Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification

Influences of Powder Packing Density in Laser Powder Bed Fusion Metal Additive Manufacturing

Study of Powder Entrainment in L-PBF Process with Maximum Hatching Space for Higher Process Efficiency

Raking process for Powder Bed Fusion of Ti-6Al-4V alloy Powder Analyzed by Discrete Element Method

Material Evaluation and Dynamic Powder Deposition Modeling of PEEK/CF Composite for Laser Powder Bed Fusion Process

An investigation into the effect of CoCrMo powder characteristics on the powder bed density in laser-based powder bed fusion units

Role of powder particle size on laser powder bed fusion processability of AlSi10mg alloy

Influence of the particle size distribution of monomodal 316L powder on its flowability and processability in powder bed fusion

Effect of Powder Variability on Laser Powder Bed Fusion Processing and Properties of 316L

Three-Dimensional Prediction of Lack-of-Fusion Porosity Volume Fraction and Morphology for Powder Bed Fusion Additively Manufactured Ti–6Al–4V

Effects of spreader geometry on powder spreading process in powder bed additive manufacturing

A Surface Quality Optimization Strategy Based on a Dedicated Melt-Pool Control Via the Dashed-Scan Contouring Technique in Electron Beam Powder Bed Fusion

Investigation of an Increased Particle Size Distribution of Ti-6Al-4V Powders Used for Laser-Based Powder Bed Fusion of Metals

Numerical simulation of the flow behavior and powder spreading mechanism in powder bed-based additive manufacturing

Effect of hard and soft re-coater blade on porosity and processability of thin walls and overhangs in laser powder bed fusion additive manufacturing

Multiscale heat transfer affected by powder characteristics during electron beam powder-bed fusion

Influence of powder size on defect generation in laser powder bed fusion of AlSi10Mg alloy

Influence of shielding gas flow consistency on parts quality consistency during large-scale laser powder bed fusion

Assessing powder processability and melting behavior in powder-bed fusion additive manufacturing