Abstract:This paper studies the impact and rebound behaviour of a thin-walled elastic-plastic circular ring after it impinges onto a rigid wall with initial velocity V-0 by finite element method. Through the dimensional analysis and a systematic simulation with different ring geometries and material properties, three non-dimensional parameters are identified, which dominate the impact duration and rebound velocity of the ring; and they are: (1) the ratio of wall thickness to average radius, eta=h/R; (2) the yield strain of the material, Y/E; and (3) the non-dimensional initial velocity of the ring, nu = V-0/V-Y, where V-Y = Y/(E rho)(1/2) denotes the yield velocity of the material [3].When the initial velocity is low, the impact between the ring and rigid plate remains elastic, the compression duration could be analytically obtained, and it agrees well with the numerical results, while the restitution duration is about 3/4 of the compression duration. The corresponding coefficient of restitution (COR) is found to be independent from the material property, whereas it increases from 0.75 to 0.78 when the thickness ratio changes from 1/20 to 1/40. With the increasing of initial velocity, a four-hinge crushing mode and a subsequent five-hinge mode are identified, which are different from the crushing mode of a ring under static compression. The variations of compression and restitution durations, rebound velocity and COR are discussed in detail, while some of them are compared with those of the impact of a solid ball onto a rigid wall. The effects of the ring geometry and material properties on these variables are also presented. The rebound velocity is found to reach the maximal at about a half of material's yield velocity when the initial velocity of the ring is about twice of the yield velocity, resulting in COR being 0.25 for all the materials and geometries adopted in this paper. (C) 2014 Elsevier Ltd. All rights reserved.

Simulation of the Impact of Two-Dimensional Elastic Disks

Dynamic Behavior of Elastic Bars and Beams Impinging on Ideal Springs

Collision and Rebound Behavior of Elastic Circular Ring Impinging on Elastic Column

Impact and Rebound of an Elastic–plastic Ring on a Rigid Target

Contact and Quasi-Static Impact of a Dissipationless Mechanical Model

Molecular dynamics simulations of head-on low-velocity collisions between particles

Impact Crushing and Rebound of Thin-Walled Hollow Spheres

Collision and Rebound of Ping Pong Balls on A Rigid Target

Numerical simulations of the normal impact of adhesive microparticles with a rigid substrate

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Elastic impact of a sphere with an elastic half-space: numerical modeling and comparison with experiment

Dynamic responses of corrugated cylindrical shells subjected to nonlinear low-velocity impact

Numerical simulation on elastic-plastic response of high speed liquid-solid impact

Numerical investigation of collision characteristics of non-spherical particles on ductile surfaces under normal impact

The Analysis and Simulation for Three-Dimensional Impact with Friction

Full-field Dynamic Response of Low-Velocity Impact on an Elastic Plate Using 3D Digital Image Correlation

Dynamics of a dry-rebounding drop: observations, simulations, and modeling

The Maximum Dissipation Principle in Rigid-Body Dynamics with Purely Inelastic Impacts

A Three-Dimensional Eulerian Method for the Numerical Simulation of High-Velocity Impact Problems

A STUDY FOR EVALUATING LOCAL DAMAGE TO REINFORCED CONCRETE PANELS SUBJECTED TO OBLIQUE IMPACT PART 2: SIMULATION ANALYSIS OF THE EXPERIMENTAL RESULTS OF LOCAL DAMAGE CAUSED BY IMPACT OF DEFORMABLE PROJECTILES