Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Computer Simulations of Friction, Lubrication and Wear

Molecular Dynamics Simulation of Friction in Self-Lubricating Materials: An Overview of Theories and Available Models

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Insights into modeling approaches for boundary- and mixed-lubricated conditions

Accurate Simulation for 2D Lubricating Materials in Realistic Environments: From Classical to Quantum Mechanical Methods

Micro-Tribology

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Modeling and simulation in tribology across scales: An overview

Surface Science In Tribology

A computer model for sliding friction in lubricated-point contacts

Nano-tribology Through Molecular Dynamics Simulations

Tribological Behavior of Very Thin Confined Films

A Simulation Method of Thermo-Mechanical and Tribological Coupled Analysis in Dry Sliding Systems

A critical assessment of surface texturing for friction and wear improvement

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Simulation of Sliding Wear in Mixed Lubrication

Structural superlubricity and ultralow friction across the length scales

Transition of frictional states and surface roughness effects in lubricated contacts

Mechanistic Studies in Friction and Wear of Bulk Materials

Thermodynamics Model for Stribeck Curve and Experiments: the Role of Interfacial Interaction