Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Surface Science In Tribology

Microscopic study of thin film lubrication and its contributions to macroscopic tribology

Micro-Tribology

Research progress of surface modification and solid–liquid lubrication synergistic friction reduction and wear resistance

Recent Progress in Thin Film Lubrication and Nano Rheology

Computer Simulations of Friction, Lubrication and Wear

A Friction Force Microscopy Study on the Surface of Au Film, Cd-Disk and Lb Film

Research Progress on the Design of Surface Texture in Tribological Applications: A Mini-Review

Advancements and Future of Tribology

Tribological mechanism of micro/meso/macroscopic textured surfaces under different normal forces, relative velocities, and sliding directions

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Molecular Behaviour In Thin Film Lubrication

Surface Force Apparatus and Thin Film Rheology for Additive-Treated Lubricant

Role of Interfacial Bonding in Tribochemical Wear

Nano-tribology Through Molecular Dynamics Simulations

Tribology of Two-Dimensional Materials: from Mechanisms to Modulating Strategies

Progress of research on nanotribology

Tribological Behavior of Very Thin Confined Films

The Roles of Surfactant in Tribology Applications of Recent Technology; an overview

Challenges to Tribology Arisen from the Development of Micro- and Nano-Manufacturing Technology

Surface Diagnostics in Tribology Technology and Advanced Coatings Development