Abstract:Pulsating heat pipes (PHPs) are widely used in the heat dissipation of electronic components, waste heat recovery, solar energy utilization, etc., relying on the pulsating flow of the work material in the pipe and the heat transfer by phase change, and they have the advantages of high heat-transfer efficiency, simple structure, and low cost. In this paper, an experimental method is used to adjust the length of local pipes in the PHP structure, so that the PHP forms a high- and low-staggered asymmetric structure, and to study the effects of different liquid charging rates and heat-source temperatures on the vibration, startup, and operation of the PHP in the asymmetric structure. We found the following: it is difficult to start up and operate the workpiece at 10%, 68%, and 80% liquid charging rates; the effect of the oscillating impact is worse; the temperature difference between the evaporation section of the pulsating heat pipe and condensation section is larger; and the temperature difference between the evaporation section and condensation section is larger. The temperature difference between the evaporation section and condensation section of the pulsating heat pipe is large, the temperature difference is between 10~25 °C, and it is difficult to achieve a small temperature difference in heat transfer. When the liquid charging rate is 30% and 50%, the pulsating heat pipe oscillates better; the pulsation frequency is relatively high; and the temperature difference between the end of the cold and hot sections is small, the temperature difference is between 3 and 7 °C, and the performance of heat transfer is better. However, when the liquid charging rate is 30% and the heat source is 70 °C, the thermal resistance is increased to 0.016 K/W, and the equivalent thermal conductivity is reduced. When the performance of heat transfer is changed to 0.016 K/W and the equivalent thermal conductivity is reduced, the coefficient decreases, and the heat-transfer performance becomes weaker.

Experimental Study on Start-up Characteristics of Pulsating Heat Pipe

Experimental Research on the Start-Up Characteristics and Heat Transfer Performance of Pulsating Heat Pipes with Rectangular Channels

Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe

Experimental investigation on heat transfer performance of closed-loop pulsating heat pipe with large inner diameter

Partial Visualization Study on Flow, Startup and Heat Transfer Characteristics of Closed-Loop Pulsating Heat Pipe with R1336mzz(Z)

Investigation on the Influence of Different Heat Transmission Distances on Thermo-Hydrodynamic Characteristics of Pulsating Heat Pipes

Effects of the Surfactant Solution on the Performance of the Pulsating Heat Pipe

Experimental Study on Start-up Process of Pulsating Heat Pipe

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Investigation of the Influence of Surfactant on the Heat Transfer Performance of Pulsating Heat Pipe

Review of the Development of Pulsating Heat Pipe for Heat Dissipation

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Performance of a Vertical Closed Pulsating Heat Pipe with Hydroxylated MWNTs Nanofluid

Transient Numerical Model on the Design Optimization of the Adiabatic Section Length for the Pulsating Heat Pipe

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Experimental Study on a Hydrogen Pulsating Heat Pipe in Different Heating Modes

Experimental Investigation on the Start-up Characteristic of a Pulsating Heat Pipe

Experimental Study on a Hydrogen Closed Loop Pulsating Heat Pipe with Different Adiabatic Lengths

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Experimental Study of Thermal Performance of Pulsating-Heat-Pipe Heat Exchanger with Asymmetric Structure at Different Filling Rates

Experimental Study on Pulsating Heat Pipe with Functional Thermal Fluids