Abstract:The evaporating section of the pulsating heat pipe (PHP) is in direct contact with the electronics when it is used for heat dissipation, and thus the evaporating temperature uniformity has an important effect on the safe and reliable operation of electronic equipment. On the basis of these conditions, an experimental study on the evaporating temperature uniformity of the PHP with surfactant solutions at different concentrations was conducted at the heat fluxes of (1911–19 427) W/m2. Sodium stearate was utilized for the solute; the surfactant solutions were prepared with the concentrations of 0.001 wt%, 0.002 wt%, and 0.004 wt%, respectively, and the filling ratios of the PHP were 0.31, 0.44 and 0.57, respectively. The experimental results revealed that under all tested working conditions, the highest temperature always appeared in the intermediate zone of the evaporating section. As the heat flux increased, the temperature differences among different zones rose initially and then reduced due to the change of the flow motion and the flow pattern. The evaporating temperature uniformity of the sodium stearate solutions-PHP was better than that of the deionized water-PHP, which suggested that the evaporating temperature uniformity might be improved through decreasing the surface tension. Furthermore, combined with the effect of surface tension and viscosity, for different filling ratios, the required concentration was different when the best evaporating temperature uniformity was achieved. To be specific, when the filling ratio were 0.31 and 0.44, the best evaporating temperature uniformity was achieved at the concentration of 0.004 wt%, while at the filling ratio of 0.57, the best evaporating temperature uniformity was attained at the concentration of 0.002 wt%.

Effects of the Surfactant Solution on the Performance of the Pulsating Heat Pipe

Experimental Investigation of the Influence of Surfactant on the Heat Transfer Performance of Pulsating Heat Pipe

Evaporating Temperature Uniformity of the Pulsating Heat Pipe with Surfactant Solutions at Different Concentrations

Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe

Partial Visualization Study on Flow, Startup and Heat Transfer Characteristics of Closed-Loop Pulsating Heat Pipe with R1336mzz(Z)

Experimental Research on the Start-Up Characteristics and Heat Transfer Performance of Pulsating Heat Pipes with Rectangular Channels

Investigation on the Influence of Different Heat Transmission Distances on Thermo-Hydrodynamic Characteristics of Pulsating Heat Pipes

Performance of a Vertical Closed Pulsating Heat Pipe with Hydroxylated MWNTs Nanofluid

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

The Impact of Gravity on the Performance of Pulsating Heat Pipe Using Surfactant Solution

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Review of the Development of Pulsating Heat Pipe for Heat Dissipation

Influence of SDBS on start time and heat transfer performance of pulsating heat pipe

Transient Numerical Model on the Design Optimization of the Adiabatic Section Length for the Pulsating Heat Pipe

Experimental investigation on heat transfer performance of closed-loop pulsating heat pipe with large inner diameter

Experimental investigation and semi-empirical correlations for a pulsating heat pipe filling with hybrid nanofluids applied for low-grade energy recovery

Experimental Study on a Hydrogen Pulsating Heat Pipe in Different Heating Modes

Experimental Study on Start-up Process of Pulsating Heat Pipe

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Experimental investigation on a pulsating heat pipe with low number of turns at liquid hydrogen temperature range

Starting and running performance of a pulsating heat pipe with micro encapsulated phase change material suspension