Abstract:Commercialization of printed photovoltaics requires knowledge of the optimal composition and microstructure of the single layers, and the ability to control these properties over large areas under industrial conditions. While microstructure optimization can be readily achieved by lab scale methods, the transfer from laboratory scale to a pilot production line ('lab to fab') is a slow and cumbersome process. Here, we show how we can optimize the performance of organic solar cells and at the same time assess process performance in a 2D combinatorial approach directly on an industrially relevant slot die coating line. This is enabled by a multi-nozzle slot die coating head allowing parameter variations along and across the web. This modification allows us to generate and analyze 3750 devices in a single coating run, varying the active layer donor:acceptor ratio and the thickness of the electron transport layer (ETL). We use Gaussian Process Regression (GPR) to exploit the whole dataset for precise determination of the optimal parameter combination. Performance-relevant features of the active layer morphology are inferred from UV-Vis absorption spectra. By mapping morphology in this way, small undesired gradients of process conditions (extrusion rates, annealing temperatures) are detected and their effect on device performance is quantified. The correlation between process parameters, morphology and performance obtained by GPR provides hints to the underlying physics, which are finally quantified by automated high-throughput drift-diffusion simulations. This leads to the conclusion that voltage losses which are observed for very thin ETL coatings are due to incomplete coverage of the electrode by the ETL, which cause enhanced surface recombination.

Optimized design for anti-reflection coating process in roll-to-roll slot-die coating system

Wide-angle Broadband Antireflection Coatings with Nano-Taper Hydrated Alumina Film.

Anti-reflection Coating at 550 Nm Fabricated by Atomic Layer Deposition

Fabrication and measurement of low polarization anti-reflection coating at 248 nm

Reduction of Coating Induced Polarization Aberrations by Controlling the Polarization State Variation

Roll-to-Roll Coating Technology and Its Applications: A Review

Reducing Light Scattering of Multilayer Dielectric High-Reflection Coatings Through Film System Optimization Design

Design of a novel anti-reflective coating with ultra-low reflectance based on resin-anchored hollow silica strategy

Ink Fluidic Behaviors during R2R Slot Die Coating on Quality Thin Film Formation

A novel teaching-learning based optimization approach for design of broad-band anti-reflection coatings

Development of Anti-Reflection (AR) Coating on Plastic Panels for Display Applications

Numerical study of slot-die coating on film formation for different die lip configurations

A Novel Non-Situ Thickness Control Method for a Single Anti-Reflection Coating Thin Film Based on Reflection Spectrum Analysis

Improved Coating Window for Slot Coating

Cutting 'lab-to fab' short: High Throughput Optimization and Process Assessment in Roll-to-Roll Slot Die Coating of Printed Photovoltaics

Design and fabrication of multilayer antireflection coating for optoelectronic devices by plasma enhanced chemical vapor deposition

Mechanically Robust Antireflective Coatings

A Novel Design For High-Temperature Solar Selective Coating

P‐109: Investigation of Low Residual Stress Anti Reflection Coating with High Hardness for Display Applications

Facile and Robust Strategy to Antireflective Photo-Curing Coating Through Self-Wrinkling

Low Cost Anti-Reflection Coating for Photovoltaic Application