Abstract:Optimization methods have been widely applied to the aerodynamic design of gas turbine blades. While applying optimization to high-fidelity computational fluid dynamics (CFD) simulations has proven capable of improving engineering design performance, a challenge has been overcoming the prolonged run-time due to the computationally expensive CFD runs. Reduced-order models and, more recently, machine learning methods have been increasingly used in gas turbine studies to predict performance metrics and operational characteristics, model turbulence, and optimize designs. The application of machine learning methods allows for utilizing existing knowledge and datasets from different sources, such as previous experiments, CFD, low-fidelity simulations, 1D or system-level studies. The present study investigates inserting a machine learning model that utilizes such data into a high-fidelity CFD driven optimization process, and hence effectively reduces the number of required evaluations of the CFD model. Artificial Neural Network (ANN) models were trained on data from over three thousand two-dimensional (2D) CFD analyses of turbine blade cross-sections. The trained ANN models were then used as surrogates in a nested optimization process alongside a full three-dimensional Navier–Stokes CFD simulation. The much lower evaluation cost of the ANN model allows for tens of thousands of design evaluations to guide the search of the best blade profiles to be used in the more expensive, high-fidelity CFD runs, improving the progress of the optimization while reducing the required computation time. It is estimated that the current workflow achieves a five-fold reduction in computational time in comparison to an optimization process that is based on three-dimensional (3D) CFD simulations alone. The methodology is demonstrated on the NASA/General Electric Energy Efficient Engine (E3) high pressure turbine blade and found Pareto front designs with improved blade efficiency and power over the baseline. Quantitative analysis of the optimization data reveals that some design parameters in the present study are more influential than others, such as the lean angle and tip scaling factor. Examining the optimized designs also provides insight into the physics, showing that the optimized designs have a lower amount of pressure drop near the trailing edge, but have an earlier onset of pressure drop on the suction side surface when compared to the baseline design, contributing to the observed improvements in efficiency and power.

Mean-line analysis and optimal design of turbines using a proper algorithm for choked conditions

A novel design and performance optimization methodology for hydraulic Cross-Flow turbines using successive numerical simulations

CFD and Taguchi based optimization of air driven single stage partial admission axial turbine blade profiles

Numerical Simulation and Aerodynamic Optimization of Two-Stage Axial High-Pressure Turbine Blades

Performance optimization of a very low head (VLH) axial turbine using surrogate model

Optimization design of radial inflow turbine combined with mean-line model and CFD analysis for geothermal power generation

CFD simulation and aerodynamic optimization of two-stage axial high-pressure turbine blades

A Mean Line Prediction Method for Axial Flow Turbine Efficiency

Investigating the effect of geometrical parameters of an optimized wind turbine blade in turbulent flow

Study on Aerodynamic Optimization Design Process of Multistage Axial Turbine

A cooled turbine blade design and optimization method considering the cooling structure influence

Radial turbine optimization under unsteady flow using nature-inspired algorithms

Aerodynamic design of a high-efficiency two-stage axial turbine, using streamline curvature method and performance optimisation by clocking of stator blades

Optimization of Turbine Blade Aerodynamic Designs Using CFD and Neural Network Models

Optimization of a high through-flow design turbine using response surface method

A comprehensive preliminary design methodology and an optimization workflow for single-stage radial-outflow turbines and application for 10 MW sCO 2 turbines

Design Optimization of Axial Flow Hydraulic Turbine Runner: Part II—multi‐objective Constrained Optimization Method

Numerical analysis and performance enhancement of a cross-flow hydro turbine

Blade Design with Three-Dimensional Viscous Analysis and Hybrid Optimization Approach

Determination of efficient configurations of vertical axis wind turbine using design of experiments

Investigation of a Novel Turbine Housing to Produce a Non-Uniform Spanwise Flow Field at the Inlet to a Mixed Flow Turbine and Provide Variable Geometry Capabilities