Abstract:An aerodynamic optimization design process of multistage axial turbine is presented in this article: first, applying quasi-three dimensional (Q3D) design methods to conduct preliminary design and then adopting modern optimization design methods to implement multistage local optimization. Quasi-three dimensional (Q3D) design methods, which mainly refer to S2 flow surface direct problem calculation, adopt the S2 flow surface direct problem calculation program of Harbin Institute of Technology. Multistage local optimization adopts the software of Numeca/Design3D, which jointly adopts genetic algorithm and artificial neural network. The major principle of the methodology is that the successive design evaluation is performed by using an artificial neural network instead of a flow solver and the genetic algorithms may be used in an efficient way. Flow computation applies three-dimensional viscosity Navier?Stokes (N-S) equation solver. Such optimization process has three features: (ⅰ) local optimization based on aerodynamic performance of every cascade; (ⅱ) several times of optimizations being performed to every cascade; and (ⅲ) alternate use of coarse grid and fine grid. Such process was applied to optimize a three-stage axial turbine. During the optimization, blade shape and meridional channel were respectively optimized. Through optimization, the total efficiency increased 1.3% and total power increased 2.4% while total flow rate only slightly changed. Therefore, the total performance was improved and the design objective was achieved. The preliminary design makes use of quasi-three dimensional (Q3D) design methods to achieve most reasonable parameter distribution so as to preliminarily enhance total performance. Then total performance will be further improved by adopting multistage local optimization design. Thus the design objective will be successfully achieved without huge expenditure of manpower and calculation time. Therefore, such optimization design process may be efficiently applied to the aerodynamic design optimization of multistage axial turbine.

CFD and Taguchi based optimization of air driven single stage partial admission axial turbine blade profiles

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

CFD simulation and aerodynamic optimization of two-stage axial high-pressure turbine blades

Aerodynamic design of a high-efficiency two-stage axial turbine, using streamline curvature method and performance optimisation by clocking of stator blades

Study on Aerodynamic Optimization Design Process of Multistage Axial Turbine

A cooled turbine blade design and optimization method considering the cooling structure influence

A Cfd Approach to Fluid Dynamic Optimum Design of Steam Turbine Stages with Stator and Rotor Blades

Numerical Simulation and Aerodynamic Optimization of Two-Stage Axial High-Pressure Turbine Blades

Fluid Dynamic Efficiency Optimization of Steam Turbine Stages Considering Leakage Influences and Inter-stage Reciprocal Interferences

A STAGE OF TEST TURBINE DESIGN AND ITS FLOW FIELD ANALYSIS

Investigation of blade design parameters for performance improvement of hydraulic cross flow turbine

Multi-Stage Turbomachinery Blades Optimization Design Using Adjoint Method And Thin Shear-Layer N-S Equations

Aerothermal Optimization of Film Cooling Hole Locations on the Squealer Tip of an HP Turbine Blade

Optimization of a high through-flow design turbine using response surface method

Mean-line analysis and optimal design of turbines using a proper algorithm for choked conditions

Three Dimensional Optimum Design Of A Steam Turbine Stage With Nurbs Curves

Aerodynamic 3-Dimensional Optimal Design by NURBS of a Certain Stage Turbine Blades

A study on an axial-type 2-D turbine blade shape for reducing the blade profile loss

A novel design and performance optimization methodology for hydraulic Cross-Flow turbines using successive numerical simulations

Theoretical and computational studies on the optimal positions of NACA airfoils used in horizontal axis wind turbine blades

Minimization of loss in small scale axial air turbine using CFD modeling and evolutionary algorithm optimization