Mechanism of dual-direction vibration-assisted (DVA) micro-milling in surface formation considering the tool life-lengthening effect on the Ti6Al4V: design and experiment
Guo Li,YuHao Li,QiuYan Liao,JiaDai Xue,Bo Wang
DOI: https://doi.org/10.1007/s00170-022-10315-y
2022-11-15
Abstract:Micro-milling is extremely paramount to fabricating micro-scaled components, requiring high quality and low setup cost. However, with the low stiffness of micro-milling systems, the uncontrolled finished surface and vulnerable wearing tools must be addressed to achieve ultra-precision processing for the thin-wall micro-structure. This paper explored the surface formation mechanism based on dual-direction vibration-assisted (DVA) micro-milling (micro-milling with vibration signals respectively applied in the feed direction and perpendicular to the feed direction) and verified the effectiveness in back chipping, analyzing the impact on chips and tool life-lengthening effect. Initially, an active vibration-assisted signal was added to the feed direction, and the integrity and quality of the machined surface model were examined. Furthermore, two groups of experiments using a Co41Cr16Ni15 double-edged end mill to micro-milling Ti6Al4V surface were carried out, compared with conventional micro-milling, analyzing the effect of the vibration-assisted device on the integrity and quality of the bottom surface of the micro-groove, and establishing a deterministic vibration-assisted micro-milling system. Finally, the effects of vibration assistance on surface topography, chip topography, and micro-milling tool runout were determined. As a result, vibration assistance improved the micro-step structure on both sides of the thin-wall micro-structure surface caused by tool eccentricity and changed the surface morphology of the groove bottom. The experiment results showed that the form deviation of the vibration-assisted micro-milling surface was less than 101 nm SPV and surface roughness was also below 25 nm RMS. Surface formation mechanism based on the vibration-assisted micro-milling system was explored to reveal that vibration assistance improves surface integrity and quality, and sharply reduced the tool's runout rate.
engineering, manufacturing,automation & control systems