Abstract:The current-voltage characteristics of superconductors are commonly determined by means of a standard 4-probe DC measurement technique. In coated conductors, however, one often encounters problems due to weak or no stabilization and in such case, when the risk of burning the tape is high, the 4-probe approach can fail. In other cases such as in HTS cable structures, besides vulnerability and high risk of damage, it may also be difficult to achieve a high critical current level with a power supply that is normally used to characterize single strands. We therefore investigated an alternative method to determine the DC I-V curve, based on measuring the AC transport loss as a function of frequency in overcritical current range. In the AC regime, both the hysteretic loss component and the joule dissipation are present for applied transport currents exceeding the critical current Ic. In this work, AC loss measurements at different frequencies are related to different electric fields in DC and a curve similar to the DC I-V is obtained. From this curve, the power index N and Ic values are estimated. AC regime operation can be more beneficial for two reasons: firstly, because very high currents can be achieved easily by using a transformer; secondly, because the effective joule heat dissipation with overcritical AC currents is much lower than that with DC of the same amplitudes. In the experiment, we used a 4 mm wide YBCO reference tape with 20 {\mu}m of Cu-stabilization. For the comparison with AC transport loss, the sample was measured with the standard 4-probe technique and remained stable even in overload condition. To support our study, numerical simulations, reproducing both transient and stationary operation conditions, were performed. A similar relation between the AC current transport loss and the I-V curves was also observed in the simulations.

How to measure the current-voltage characteristics of Ohmic conductors and superconductors

Current-voltage Characteristics and Parameter Retrieval of Semiconducting Nanowires

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

High Tc superconductor voltage-current simulator and the pulse method of measuring critical current

High temperature setup for measurements of Seebeck coefficient and electrical resistivity of thin films using inductive heating

MEASUREMENT OF CRITICAL CURRENT FOR HIGH TEMPERATURE SUPERCONDUCTORS

Establishing Ohmic contacts for in situ current-voltage characteristic measurements on a carbon nanotube inside the scanning electron microscope.

Nondestructive measurement of conductivity of doped GaAs using compact microwave instrument

Ohm's law revision

Novel circuit design for high-impedance and non-local electrical measurements of two-dimensional materials

Measuring kinetic inductance and superfluid stiffness of two-dimensional superconductors using high-quality transmission-line resonators

Measurements and analysis of current-voltage characteristic of a pn diode for an undergraduate physics laboratory

Measurement of junction conductance and proximity effect at superconductor/semiconductor junctions

Dissipative-regime measurements as a tool for confirming and characterizing near-room-temperature superconductivity

Fundamentals of Measurement: Small Electric Currents

Contactless Measurement of Critical Current of High Temperature Superconductor Tape by Magnetic Circuit.

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

Nonlinear I-V Characteristics of a Mesoscopic Conductor

AC Measurement of the Nernst effect of thin films at low temperatures

Analysis of experimental conditions for simultaneous measurements of transport and magnetotransport coefficients of high temperature superconductors

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance