Abstract:Recent work indicates that the high-velocity oxy-fuel (HVOF) thermal spraying WC-Co coatings have been used to enhance the wear resistance of various engineering components in a variety of industrial environments. In the present work, WC-Co powder, containing Cr particles in an amount of 10%, was deposited on ductile cast iron with the HVOF thermal spray coating technique. An investigation was conducted to determine the role of Cr particles in the WC-Co coating produced with the HVOF technique on microstructure, mechanical, and wear properties in a system of type: WC-Co coating/ductile cast iron. The microstructure of the HVOF-sprayed WC-Co + Cr coating was characterised by light microscopy, X-ray diffraction (XRD), scanning electron microscope (SEM), transmission electron microscope (TEM), and energy-dispersive X-ray spectroscopy (EDS). The analysis of the microstructure showed the formation of a coating with low porosity, compact structure, and good adhesion to the substrate with a typical lamellar structure composed of fine molten Cr particles and finely fragmented WC grains embedded in a Co matrix, reaching the size of nanocrystalline. The scratch test was applied for the analysis of the adhesion of coatings to the substrate. The erosion behaviour and mechanism of material removal was studied and discussed based on microstructural examinations. Moreover, the results were discussed in relation to the bending strength test, including cracks and delamination in the system of the WC-Co + Cr/ductile cast iron, as microhardness and erosion resistance of the coating. It was found that the addition of Cr particles to the WC-Co powder, which causes hardening of the binder phase is a key influence on increased mechanical and wear properties in the studied system. Additionally, due to the construction of nanostructured coatings, suitable proportion of hard and soft phases, the technique sprayed HVOF coatings have advantageous properties such as high density and good slurry erosion resistance.

A study of microstructures and corrosion behavior of HVOF/PVD duplex coating against 10 vol% HCl solution

Achieving superior hot corrosion resistance by PVD/HVOF duplex design

Corrosive wear behavior of HVOF-sprayed micro-nano-structured Cr3C2–NiCr cermet coatings under aqueous media

Uniform Microstructure and Excellent Corrosion Resistance of HVOF-Sprayed CoCrNi Medium-Entropy Alloy Coating in Fluoride Ion Environment

An HVOF-Sprayed (Cr3C2-NiCr+Co) Composite Coating on Ductile Cast Iron: Microstructure, Mechanical Properties, and Scratch Resistance

Corrosion Behavior of NiCrBSi Coatings Deposited by HVOF Spraying

Mechanical and High-Temperature Tribological Properties of Cr3C2-NiCr/TiN Duplex Coating

Corrosion of high-velocity-oxygen-fuel (HVOF) sprayed non-crystalline alloy coating in marine environment

Effect of the microstructure of corrosion products on tribo-corrosion performance of HVOF-sprayed NiCrWMoCuCBFe coating

Mechanism of coupling corrosion caused by flue gas and deposits in municipal solid waste incinerator: Resistance of HVOF-NiCr coating

Double Layer HVAF-sprayed WC-CoCr Coatings for Optimal Properties

Effects of high-velocity oxygen fuel metal-ceramic interlayer on the mechanical and tribological properties of Si/DLC-coated Ti-6Al-4V alloy

Preparation process, surface properties and mechanistic study of HVAF-sprayed CoCrFeNiMo 0.2 high-entropy alloy coatings

Investigation on Microstructure, Mechanical and Wear Properties of HVOF Sprayed Composite Coatings (WC-Co + CR) On Ductile Cast Iron

Enhancing the High-Temperature Corrosion Resistance of HVOF-sprayed NiCoCrAlY Coating in Marine Environment by Pt Modification and Pre-Oxidation

Effect of Stellite12 and NiCrBSi HVOF coatings on the tribological behavior of CrN PVD film

Interfacial Alloying Between Expanded Austenite and Ti(AlCu)N Coating for Enhanced Cavitation Erosion Resistance

Corrosion and Wear Resistance of HVOF-Sprayed Ni-Cr-Co Multi-principal Element Alloy Coating on Copper Plate

Evaluation of cavitation/corrosion synergy of the Cr3C2-25NiCr coating deposited by HVOF process

Effect of vacuum heat treatment on microstructure and corrosion behavior of HVOF sprayed AlCoCrFeNiCu high entropy alloy coatings

EFFECT OF C2H2 FLOW RATE ON THE DEPOSITION OF TI-TIC-TIC/DLC GRADIENT NANO-COMPOSITE FILM ON NITI ALLOY