Abstract:Abstract During different airplane flight modes, various effects may appear that need to be analyzed for both the oil and the fuel system at steady-state and transient operating modes. The effects, which relate to the cold temperature, associated with fuel freeze or wax point, cause a malfunction in the fuel pumps, nozzles, and other areas of the fuel system. On the other hand, high fuel temperature also leads to negative effects — the most common failure of high-flow fuel systems is cavitation, or “vapor-lock.” The combination of too much heat or too much inlet restriction can create this operating condition, where the liquid fuel literally boils inside the fuel pump. These effects are eliminated by the fuel/oil heat exchange system. In case of low fuel temperature, the fuel is used as a refrigerant to cool down hot oil coming from bearings. And in case of high fuel temperature, the oil serves as a coolant. This paper considers the method of evaluating normal and critical aircraft engine operation modes of the oil supply system with a fuel-oil heat exchanger utilizing an unsteady-state thermal-fluid network approach. The analyses are done based on the aircraft engine example to evaluate fuel and oil systems parameters variation in time under different flight conditions — the amount of fuel in the tank, inertial thermal effects, and the response time of the system to the regulation of the heat exchanger. The article is focused on sudden switching from a high to low gas engine operating mode. Fuel consumption to the engine is reduced abruptly, but the heat transfer from the bearings to the oil is still high due to thermal inertia. In this situation, a large amount of heated fuel must be returned to the fuel tank. At a certain point in time, the temperature of the fuel can reach a critical value. At the same time bearing cooling becomes ineffective, which leads to overheating. The calculation of thermal management system was performed at nominal conditions to obtain the initial data for low power settings analysis. As results of analysis at the low power settings mode the oil temperature before fuel cooled oil cooler is reached above 138 °C, which is high value. The failure of flow return valve is considered. The variations of oil temperature after the tank and increasing of fuel temperature at the tank in case of emergency situation are obtained. The influence of cooled fuel amount on the system thermal management is analyzed.

Aircraft fuel system energy and exergy analysis under hot day conditions

Transient Analysis of Aircraft Oil Supply System With Fuel-Oil Heat Exchangers During Abrupt Change in Engine Operating Modes

Analysis of Aircraft Fuel Thermal Management System Under Different Architectures

Energetic and exergetic metrics of a cargo aircraft turboprop propulsion system by using regression method for dynamic flight

Exergy analysis of a three-spool turboprop engine during the flight of a cargo aircraft

Energy, exergy, thermoecologic, environmental, enviroeconomic and sustainability analyses and assessments of the aircraft engine fueled with biofuel and jet fuel

Aircraft Gas Turbine Engine Health Monitoring System by Real Flight Data

Systematic benchmarking of performance, environmental and sustainability impacts of utilization of alternative cleaner fuel in an aircraft gas turbine engine

Performance analysis of a new multifunctional aircraft environmental control system under variable operating conditions

Transient Simulation on Flow and Heat Transfer Characteristics of Aeroengine Fuel-Oil Thermal Management System

Thermal management of fuel heat sink in aircraft via flow path optimization

Optimization Research on the Heat Transfer Capacity of an Aircraft Fuel Thermal Management System

Exergy analysis of a turboprop engine at different flight altitude and speeds using novel consideration

Thermal performance of gas turbine power plant based on exergy analysis

Comparing different piston-prop aircraft engines with combustion efficiency and exergy

Thermodynamic-based environmental and enviroeconomic assessments of a turboprop engine used for freight aircrafts under different flight phases

Investigation of A Biomass Gasification System Based on Energy and Exergy Analysis

Energy And Exergy Analysis For A New Models With Gradual Expansion Combined With Multiple Power Generation Systems

Life cycle assessment and exergoenvironmental analyses for making a decision in the fuel selection for aero-engines: An application for a medium-size turboprop engine (m-TPE)

Thermodynamics, Environmental and Sustainability Impacts of a Turbofan Engine Under Different Design Conditions Considering Variable Needs in the Aviation Industry

Evaluation of high-speed aircraft thermal management system based on spray cooling technology: Energy analysis, global cooling, and multi-objective optimization