Abstract:Summary A laboratory study of the alkaline-surfactant-polymer (ASP) process was conducted. It was found from phase-behavior studies that for a given synthetic surfactant and crude oil containing naph-thenic acids, optimal salinity depends only on the ratio of the moles of soap formed from the acids to the moles of synthetic surfactant present. Adsorption of anionic surfactants on carbonate surfaces is reduced substantially by sodium carbonate, but not by sodium hydroxide. The magnitude of the reduction with sodium carbonate decreases with increasing salinity. Particular attention was given to a surfactant blend of a pro-poxylated sulfate having a slightly branched C16–17 hydrocarbon chain and an internal olefin sulfonate. In contrast to alkyl/aryl sulfonates previously considered for EOR, alkaline solutions of this blend containing neither alcohol nor oil were single-phase micellar solutions at all salinities up to approximately optimal salinity with representative oils. Phase behavior with a west Texas crude oil at ambient temperature in the absence of alcohol was unusual in that colloidal material, perhaps another microemulsion having a higher soap content, was dispersed in the lower-phase microemulsion. Low interfacial tensions existed with the excess oil phase only when this material was present in sufficient amount in the spinning-drop device. Some birefringence was observed near and above optimal conditions. While this phase behavior is somewhat different from the conventional Winsor phase sequence, overall solubilization of oil and brine for this system was high, leading to low interfacial tensions over a wide salinity range and to excellent oil recovery in both dolomite and silica sandpacks. The sandpack experiments were performed with surfactant concentrations as low as 0.2 wt% and at a salinity well below optimal for the injected surfactant. It was necessary that sufficient polymer be present to provide adequate mobility control, and that salinity be below the value at which phase separation occurred in the polymer/surfactant solution. A 1D simulator was developed to model the process. By calculating transport of soap formed from the crude oil and injected surfactant separately, it showed that injection below optimal salinity was successful because a gradient in local soap-to-surfactant ratio developed during the process. This gradient increases robustness of the process in a manner similar to that of a salinity gradient in a conventional surfactant process. Predictions of the simulator were in excellent agreement with the sandpack results.

Alkyl polyglycoside surfactant–alcohol cosolvent formulations for improved oil recovery

Alkyl Polyglycoside/1-naphthol Formulations with Ultra-low Interfacial Tensions Against N-octane for Enhanced Oil Recovery

Alkyl Polyglycoside/1-Naphthol Formulations: A Case Study of Surfactant Enhanced Oil Recovery

Alkyl Polyglucosides for Potential Application in Oil Recovery Process: Adsorption Behavior in Sandstones under High Temperature and Salinity

A Study of Branched Alcohol Propoxylate Sulfate Surfactants for Improved Oil Recovery

Polyetheramine enhanced biosurfactant/biopolymer flooding for enhanced oil recovery

Synergistic anionic/zwitterionic mixed surfactant system with high emulsification efficiency for enhanced oil recovery in low permeability reservoirs

Numerical Investigation on Alkaline-Surfactant-Polymer Alternating CO2 Flooding

Design and application of an alkaline–surfactant–polymer (ASP) slug for enhanced oil recovery: a case study for a depleted oil field reservoir

Analysis of the Influence of Alkyl Polyglycoside Surfactant and Cosolvent Structure on Interfacial Tension in Aqueous Formulations versus n-Octane

An Experimental Investigation into the Potential of a Green Alkali-Surfactant-Polymer Formulation for Enhanced Oil Recovery in Sandstone Reservoir

Laboratory studies on a novel salt-tolerant and alkali-free flooding system composed of a biopolymer and a bio-based surfactant for oil recovery

Favorable Attributes of Alkali-Surfactant-Polymer Flooding

Study on the Performance Mechanism of Polyformaldehyde Glycol Ether Polymer for Crude Oil Recovery Enhancement.

Experimental Study of Enhancing Oil Recovery with Weak Base Alkaline/Surfactant/Polymer

Systematic Investigation of the Physicochemical Properties of Eco-Friendly Biobased Anionic-Nonionic Surfactants for Enhanced Oil Recovery

Improved Oil Recovery by Chemical Flood from High Salinity Reservoirs-Single-Well Surfactant Injection Test

Field Application of Alkali/Surfactant/Polymer Flood with Novel Mixtures of Anionic/Cationic Surfactants for High-Temperature and High-Water-Cut Mature Sandstone Reservoir

Zwitterionic-nonionic compound surfactant system with low chromatographic separation effect for enhanced oil recovery

Surfactant-Enhanced Assisted Spontaneous Imbibition for Enhancing Oil Recovery in Tight Oil Reservoirs: Experimental Investigation of Surfactant Types, Concentrations, and Temperature Impact

Surfactant-polymer flooding formulated with commercial surfactants and enhanced by negative salinity gradient