Abstract:The chirped pulse amplification technique has enabled the generation of pulses of a few femtosecond duration with peak powers multi-Tera and Peta–Watt in the near infrared. Its implementation to realize even shorter pulse duration, higher energy, and higher repetition rate laser systems relies on overcoming the limitations imposed by laser damage of critical components. In particular, the laser damage of coatings in the amplifiers and in post-compression optics have become a bottleneck. The robustness of optical coatings is typically evaluated numerically through steady-state simulations of electric field enhancement in multilayer stacks. However, this approach cannot capture crucial characteristics of femtosecond laser induced damage (LID), as it only considers the geometry of the multilayer stack and the optical properties of the materials composing the stack. This approach neglects that in the interaction of an ultrashort pulse and the materials there is plasma generation and associated material modifications. Here, we present a numerical approach to estimate the LID threshold of dielectric multilayer coatings based on strong field electronic dynamics. In this dynamic scheme, the electric field propagation, photoionization, impact ionization, and electron heating are incorporated through a finite-difference time-domain algorithm. We applied our method to simulate the LID threshold of bulk fused silica, and of multilayer dielectric mirrors and gratings. The results are then compared with experimental measurements. The salient aspects of our model, such as the implementation of the Keldysh photoionization model, the impact ionization model, the electron collision model for ‘low’-temperature, dense plasma, and the LID threshold criterion for few-cycle pulses are discussed.

Thermomechanical issues of high power laser diode catastrophic optical damage

Researches on Laser Damage Resistance of Optical Films

Investigation On Transient Catastrophic Optical Damage In High Power Aigaas/Gaas Laser Diodes

About the physical meaning of the critical temperature for catastrophic optical damage in high power quantum well laser diodes

Influence of Optical Field Design on Catastrophic Optical Damage in Laser Chips

Laser-Induced Damage Initiation and Growth of Optical Materials

Transient Dynamic Behavior During Nanosecond Laser-Induced Damage Initiated by Surface Defects on KDP Crystals with Simulation and Experimental Method

Laser-induced Damage in a Silicon-Based Photodiode by MHz Picosecond Laser

Laser Induced Damage of Optical Elements–a Status Report

Improvement of cavity films and catastrophic optical damage on 980 nm semiconductor laser

Ultrafast Laser Material Damage Simulation—A New Look at an Old Problem

Dynamic behavior modeling of laser-induced damage initiated by surface defects on KDP crystals under nanosecond laser irradiation

Localized Dynamics during Laser-Induced Damage in Optical Materials

Initial energy deposition and initiation mechanism of nanosecond laser damage caused by KDP surface micro-defects

Temporal Scaling Law and Intrinsic Characteristic of Laser Induced Damage on the Dielectric Coating

Catastrophic Degradation of Ingan/Gan Blue Laser Diodes

Thermal and Mechanical Breakage Induced by High Power Laser on Optical and Photoelectric Elements

Evolution of Laser-Induced Bulk Damage in KDP Crystal

Laser damage evolution by defects on diamond fly-cutting KDP surfaces

On the Ultra-Precision Fabrication of Damage-Free Optical KDP Components: Mechanisms and Problems

Structural Defects and Degradation Phenomena in High-Power Pure-Blue InGaN-Based Laser Diodes.