Abstract:The chirped pulse amplification technique has enabled the generation of pulses of a few femtosecond duration with peak powers multi-Tera and Peta–Watt in the near infrared. Its implementation to realize even shorter pulse duration, higher energy, and higher repetition rate laser systems relies on overcoming the limitations imposed by laser damage of critical components. In particular, the laser damage of coatings in the amplifiers and in post-compression optics have become a bottleneck. The robustness of optical coatings is typically evaluated numerically through steady-state simulations of electric field enhancement in multilayer stacks. However, this approach cannot capture crucial characteristics of femtosecond laser induced damage (LID), as it only considers the geometry of the multilayer stack and the optical properties of the materials composing the stack. This approach neglects that in the interaction of an ultrashort pulse and the materials there is plasma generation and associated material modifications. Here, we present a numerical approach to estimate the LID threshold of dielectric multilayer coatings based on strong field electronic dynamics. In this dynamic scheme, the electric field propagation, photoionization, impact ionization, and electron heating are incorporated through a finite-difference time-domain algorithm. We applied our method to simulate the LID threshold of bulk fused silica, and of multilayer dielectric mirrors and gratings. The results are then compared with experimental measurements. The salient aspects of our model, such as the implementation of the Keldysh photoionization model, the impact ionization model, the electron collision model for ‘low’-temperature, dense plasma, and the LID threshold criterion for few-cycle pulses are discussed.

Influence of Optical Field Design on Catastrophic Optical Damage in Laser Chips

Researches on Laser Damage Resistance of Optical Films

Theoretical Analysis of Thermal-Lensing Effect in a High Power Exciplex Pumped Cs Vapor Laser.

Investigation On Transient Catastrophic Optical Damage In High Power Aigaas/Gaas Laser Diodes

Thermomechanical issues of high power laser diode catastrophic optical damage

Influences of Operating Parameters on Deleterious Processes of Side-Pumped Cesium Vapor Laser Amplifiers with Flowing Medium

Analysis Of Nonlinear Self-Focusing Phenomenon In High-Power Laser System Based On Ray-Tracing

Study on design of high-power fiber fused components

Laser-induced Damage in a Silicon-Based Photodiode by MHz Picosecond Laser

Laser damage evolution by defects on diamond fly-cutting KDP surfaces

Design of laser beam dump with high laser-induced-damage threshold

Dynamic behavior modeling of laser-induced damage initiated by surface defects on KDP crystals under nanosecond laser irradiation

A Design of Debris Mitigation System for High-Repetition-rate Petawatt Laser Experiments

Prior-damage Dynamics in a High-Finesse Optical Enhancement Cavity

Processes of the Reliability and Degradation Mechanism of High-Power Semiconductor Lasers

Ultrafast Laser Material Damage Simulation—A New Look at an Old Problem

Calculation of Laser Irradiation Effect and Analysis of Laser-Induced Damage Threshold in Semiconductor

On the Ultra-Precision Fabrication of Damage-Free Optical KDP Components: Mechanisms and Problems

Analytic Calculation and Evaluation of Thermal and Mechanical Damage in Optical Materials Induced by Laser

Elimination of Spatial Hole Burning in Microlasers for Stability and Efficiency Enhancement

Research on Laser-Induced Damage Post-Restoration Morphology of Fused Silica and Optimization of Patterned CO2 Laser Repair Strategy