Abstract:By adopting polymer/silica hybrid rib waveguide structure,a low power-consumption Mach-Zehnder interferometer(MZI) thermo-optic switch is designed and fabricated with techniques including chemical vapor deposition(CVD),spin-coating,wet-etching,etc.The wavelength dispersions of waveguide core,buffer and cladding materials are measured,and output power and output spectrum are theoretically analyzed.Switching response and spectrum characteristics are measured using a tunable laser as input source.Under 1 550 nm wavelength,the driving power of the switch is about 7.8 mW,the extinction ratio between ON state and OFF state is up to 32.6 dB,and under the function of pure square-wave switching signal(peak-to-peak amplitude of 3Vpp),the rising time and falling time are 107 μs and 71 μs,respectively.Keeping applying the driving power at 1 550 nm wavelength on the device,the measured spectrum width is about 50 nm(1 520-1 570 nm) with an extinction ratio over 18 dB.A noise-level-tunable driving source is developed with NE555 and other integrated circuits,and then the driving-noise-tolerance characteristics are investigated.Experimental results indicate that the allowed maximum noise-level is about 1.1 Vpp with a required extinction ratio larger than 10 dB.The proposed results in this paper are of good meanings for practical applications of such thermo-optic switches with the hybrid waveguide structure.

Polymer/Silica Hybrid Waveguide Thermo-Optic VOA Covering O-Band

Polymer-Based Variable Optical Attenuator

Compact variable optical attenuator based on multimode interference coupler

Research Development of Variable Optical Attenuator

Low-Power-Consumption and Broadband 16-Channel Variable Optical Attenuator Array Based on Polymer/Silica Hybrid Waveguide

TDFA-BAND SILICON OPTICAL VARIABLE ATTENUATOR

A Multimode Interference Polymer-Silica Hybrid Waveguide 2x2 Thermo-Optic Switch

Compact Variable Optical Attenuator Based on the W Type Waveguide

Low-Power And High-Speed Thermo-Optic Switch Using Hybrid Silica/Polymer Waveguide Structure: Design, Fabrication And Measurement

Low consumption power variable optical attenuator with sol-gel derived organic/inorganic hybrid materials.

Variable Optical Attenuator with a Polymer-Stabilized Dual-Frequency Liquid Crystal.

Design and Performance Analysis of Silica-Based Thermo-Optical Switches Operating in O-Band and C-Band

Three-Dimensional Polymer Variable Optical Attenuator Based on Vertical Multimode Interference with Graphene Heater

Variable Optical Attenuator Based on a PDMS-Embedded Microfiber Coupler

Variable Optical Attenuator Based on a Reflective Mach–Zehnder Interferometer

Variable Optical Attenuator Based on Photonic Crystal Waveguide with Low-Group-index Tapers.

Digitally Controlled Programmable High‐speed Variable Optical Attenuator

Fabrication and Driving-Noise-tolerance Characteristics of Wide-Spectrum Polymer Thermo-Optic Switch

High-speed electrooptical VOA integrated in silicon-on-insulator

Design and Attenuation Analysis for Fiber-Typed Variable Optical Attenuator Based on Thermo-Optic Effect

Design and Fabrication of A Variable Optical Attenuator Based on Polymer-Dispersed Liquid Crystal