Abstract:In order to obtain a low polarization dependent loss (PDL) and a large attenuation range simultaneously, an optimal design and fabrication of a polymer-dispersed liquid crystal (PDLC) based variable optical attenuator (VOA) is presented. First, an optimal diameter of the liquid crystal droplets is determined by the anomalous diffraction approach (ADA). This optimal diameter gives maximal scattering and thus a large attenuation range is achieved with a relatively thin liquid crystal cell. Secondly, the fabrication of PDLC cell is carried out. The influence of the ultraviolet (UV) curing condition on the morphology of the LC droplets is investigated. For a given liquid crystal concentration, the optimal UV curing power is obtained after a series of statistically designed experiments. Finally, an optical configuration of the PDLC based VOA is presented. Measurements of the attenuation and the PDL are carried out with this configuration. The measured results show that the device has a typical attenuation range of 25dB. The corresponding PDL is nearly 1 dB and the insertion loss is 1.80. The threshold voltage is 8 Vrms and the saturation voltage is 40 Vrms. From these measured results, one can see that the fabricated VOA based on PDLC is much more practical for optical communications as compared to the existing ones.

Variable Optical Attenuator Based on Photonic Crystal Waveguide with Low-Group-index Tapers.

Polymer-Based Variable Optical Attenuator

Compact Variable Optical Attenuator Based on the W Type Waveguide

Ultracompact Variable Optical Attenuator Based on Photonic Crystal Waveguide

Buckling-induced Wavy Optical Fiber Attenuator.

Ultra-compact Variable Optical Attenuator Based on Slow Light Photonic Crystal Waveguide

Research Development of Variable Optical Attenuator

TDFA-BAND SILICON OPTICAL VARIABLE ATTENUATOR

Compact variable optical attenuator based on multimode interference coupler

Digitally Controlled Programmable High‐speed Variable Optical Attenuator

Variable Optical Attenuator with a Polymer-Stabilized Dual-Frequency Liquid Crystal.

Variable Optical Attenuator Based on a PDMS-Embedded Microfiber Coupler

Linbo3 Based S-Bend Waveguide Variable Optical Attenuator

Analysis and optimization of an InGaAsP/InP waveguide variable optical attenuator

Thermal Gradient Driven Variable Optical Attenuator With On-Chip CNT Absorber

Dual-Frequency Addressed Variable Optical Attenuator with Submillisecond Response Time

Micromachining-based fiber-coupled variable optical attenuator

Design and Fabrication of A Variable Optical Attenuator Based on Polymer-Dispersed Liquid Crystal

A Novel Variable Optical Attenuator Based On Two Detuned Coupled Rings

Design and Attenuation Analysis for Fiber-Typed Variable Optical Attenuator Based on Thermo-Optic Effect

Polymer/Silica Hybrid Waveguide Thermo-Optic VOA Covering O-Band