Abstract:MÖNCH is a hybrid pixel detector featuring 25 μm pixel pitch and analogue readout for X-ray imaging at synchrotron radiation (SR) facilities. Sub-pixel spatial resolution has been demonstrated using charge sharing and interpolation algorithms. The current prototype version, MÖNCH0.4, features 19 different pixel architectures to assess the design choices and components for an optimised architecture to be used at SR facilities, and to explore the potential use of dynamic gain switching in fine pitch pixels for applications at X-ray free electron lasers (XFELs). Previous characterisation results of the pixel architectures without dynamic gain switching have shown noise levels as low as 21.7 e - r.m.s., which have now been pushed to sub-20 e - r.m.s at room temperature using standard 300 μm-thick silicon sensors. Achieving low noise values however requires high conversion gain and necessitates design choices such as the simplification of the pixel architecture (e.g. by limiting the available choice of in-pixel gains). These compromises ultimately restrain the available dynamic range and prevent the use of MÖNCH with low-gain avalanche diodes (LGADs) or high-Z sensors because of the large signals (internal amplification and high photon energies, respectively) and of large leakage currents. In this paper, we will introduce the MÖNCH project followed by a description of the current prototype along with characterisation results of the pixel architectures without dynamic gain switching for synchrotron applications with an emphasis on noise and dynamic range. These experimental results will be used to fine-tune the design of MÖNCH0.5 to validate the final pixel design. This small prototype should also include additional features from the continuous developments of the PSD detector group towards a full-scale 2 × 3 cm 2 MÖNCH1.0.

What problem does this paper attempt to address?

This paper attempts to solve the problem of balancing gain and dynamic range in a hybrid pixel detector with a 25 µm pixel pitch. Specifically, the MÖNCH project aims to develop a hybrid pixel detector with a 25 µm pixel pitch and analog read - out function for X - ray imaging in synchrotron radiation facilities. The paper explores in detail the design choices of different pixel architectures and their impact on noise and dynamic range, especially the application of static gain and Dynamic Gain Switching (DGS). ### Main problems: 1. **Trade - off between low noise and high gain**: - In order to achieve low noise, a high conversion gain is required, which usually requires simplifying the pixel architecture (for example, limiting the gain selection within the pixel). However, these compromises will ultimately limit the available dynamic range, and when using low - gain avalanche diodes (LGADs) or high - Z sensors, MÖNCH cannot be used due to internal amplification, large signals generated by high photon energy, and large leakage current. 2. **Extension of dynamic range**: - For applications in X - ray free - electron lasers (XFELs), a single pixel may receive several thousand photons per bunch, and dynamic gain switching is required to keep the electronic noise below the photon number statistical fluctuations. The paper explores how to extend the dynamic range through dynamic gain switching while maintaining low - noise performance. ### Solutions: - **Static - gain pixel design**: - The paper introduces 19 different pixel architectures in the MÖNCH0.4 prototype, of which 5 static - gain pixel architectures are described and tested in detail. These designs achieve different noise and dynamic range performances by adjusting the capacitance value and gain settings. - **Dynamic gain switching**: - The dynamic gain switching technique can automatically switch to the low - gain mode when a large signal is detected, thereby avoiding saturation, while maintaining a high gain for small signals to improve the signal - to - noise ratio. The paper preliminarily tests the effect of dynamic gain switching, but does not show the results in detail. ### Experimental results: - **Noise performance**: - Through laboratory tests, the paper shows the noise performance of different static - gain pixel architectures. The optimized design (such as SHG + Cfilt) reaches a noise level below 20 e - r.m.s. at room temperature. - **Dynamic range**: - The dynamic range was tested using a laser source, and the results show that the dynamic range is directly related to the gain. The low - gain configuration provides a very high dynamic range (up to 163 × 12 keV photons), but has higher noise. Conversely, the high - gain configuration provides lower noise performance (18–70 e - r.m.s.), but has a limited dynamic range (2–17 × 12 keV photons). ### Future directions: - **MÖNCH0.5 prototype**: - Based on the test results of MÖNCH0.4, it is planned to design a 4 × 4 cm² MÖNCH0.5 prototype containing 160 × 160 pixels. This prototype will be used for further verification and optimization of the design, with the ultimate goal of developing a full - size MÖNCH1.0. - **Challenges and solutions**: - The main challenges faced by large - scale devices include power distribution, data transmission, and storage. The paper proposes a real - time data compression strategy to address the challenge of large data volumes. In conclusion, this paper provides important references and guidance for the future design of hybrid pixel detectors through detailed testing and analysis of the performance of different pixel architectures.

Balancing gain and dynamic range in a 25 μm pitch hybrid pixel detector

Optimizing charge transport simulation for hybrid pixel detectors

Enhancing spatial resolution in MÖNCH for electron microscopy via deep learning

Novel sensor developments for photon science at the MPG semiconductor laboratory

20 ps Time Resolution with a Fully-Efficient Monolithic Silicon Pixel Detector without Internal Gain Layer

High Dynamic Range X-ray Detector Pixel Architectures Utilizing Charge Removal

Cross talk of a large-scale depleted monolithic active pixel sensor (DMAPS) in 180 nm CMOS technology

Cross-talk of a large-scale depleted monolithic active pixel sensor (DMAPS) in 180Â nm CMOS technology

Charge collection and efficiency measurements of the TJ-Monopix2 DMAPS in 180$\,$nm CMOS technology

Towards a New Generation of Monolithic Active Pixel Sensors

Characterisation of AMS H35 HV-CMOS monolithic active pixel sensor prototypes for HEP applications

Characterisation of analogue Monolithic Active Pixel Sensor test structures implemented in a 65 nm CMOS imaging process

A Finely Segmented Semi-Monolithic Detector tailored for High Resolution PET

The Monopix chips: Depleted monolithic active pixel sensors with a column-drain read-out architecture for the ATLAS Inner Tracker upgrade

Resolving soft X-ray photons with a high-rate hybrid pixel detector

Design and Performance of HV CMOS Sensors for Future Colliders by the RD50 Collaboration

Evaluation and synthesis of perovskite crystals as high-Z sensors for hybrid pixel detectors

X-ray imaging using a hybrid photon counting GaAs pixel detector

Developing a Monolithic Silicon Sensor in a 65 nm CMOS Imaging Technology for Future Lepton Collider Vertex Detectors

First results on monolithic CMOS detector with internal gain