Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Ni nanoparticles supported on Al2O3 + La2O3 yolk-shell catalyst for photo-assisted thermal decomposition of methane

Unveiling the Roles of Precursor Structure and Controlled Sintering on Ni-Phyllosilicate-Derived Catalysts for Low-Temperature Methane Decomposition

Photoinducing Different Mechanisms on a Co-Ni Bimetallic Alloy in Catalytic Dry Reforming of Methane

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

NiO@Ni nanoparticles embedded in N-doped carbon for efficient photothermal CO2 methanation coupled with H2O splitting

Insight into the moderate interaction between the metal and support and reinforcing of Ni/SiO 2 -based catalysts efficiency with the manganese integration in thermal catalytic methane decomposition

Photothermal methane coupling into liquid fuels with hydrogen evolution over nanocatalysts based on layered double hydroxide (LDH)

Highly Active and Stable Lanthanum‐doped Core–Shell‐structured Ni@SiO2 Catalysts for the Partial Oxidation of Methane to Syngas

Methane pyrolysis on NiMo/MgO catalysts: the significance of equimolar NiMo alloy resisting nanosize segregation during the reaction

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Methane Combustion with a Pd–Pt Catalyst Stabilized by Magnesia–Alumina Spinel in a High-Humidity Feed

Enhanced photothermal catalytic performance of dry reforming of methane over Ni/mesoporous TiO2 composite catalyst

Nano-sized alumina supported palladium catalysts for methane combustion with excellent thermal stability

Effect of nickle on cerium oxide support to develop cyclic catalytic methane decomposition followed by CO 2 gasification

Partial Thermal Condensation Mediated Synthesis of High-Density Nickel Single Atom Sites on Carbon Nitride for Selective Photooxidation of Methane into Methanol

Effect of Nanostructured Supports on Catalytic Methane Decomposition

Three-dimensional porous Mn–Ni/Al2O3 microspheres for enhanced low temperature CO hydrogenation to produce methane

Ternary NiMo-Bi liquid alloy catalyst for efficient hydrogen production from methane pyrolysis

Thermocatalytic Decomposition of Methane Over NiO–MgO Catalysts Synthesized by the Mechanochemical Method

Highly active Ni/Al2O3 catalyst for CO2 methanation by the decomposition of Ni-MOF@Al2O3 precursor via cold plasma

Catalytic Methanation of Syngas over Ni-based Catalysts with Different Supports