Abstract:We report here the first coupling of fast GC to IRMS, in a system capable of 250 ms peak widths (fwhm) at 1 mL/min flow rates, one-fifth as narrow as any previously reported GCC-IRMS system. We developed an optimized postcolumn interface that results in minimal peak broadening, using a programmable temperature vaporization injector in place of a rotary valve or backflush system to divert solvent, a narrow capillary combustion reactor followed by a cryogenic water trap with narrow-bore (< 0.20 mm We transfer lines, and a narrow W. open split to the IRMS directly inserted into the column effluent. Quantitative combustion was demonstrated with CH4 injections. A comparison of CO2 injections with different fwhm peak widths (250, 2500, and 7500 ms) showed similar precisions, SD(delta C-13) = 0.2-0.3 parts per thousand, for injections of > 600 pmol C on column; precision for the narrow peaks (250 ms) was considerably better for injections < 150 pmol C on column. SD(delta C-13) < 1 parts per thousand was achievable for injections of 5-15 pmol on column for 250 ms wide peaks, 10-fold better precision than 2500 ms wide peaks, and within a factor of 3 of the counting statistics Emit For a mixture of 15 fatty acid methyl esters (FAME), 1.5 nmol C of each on column yielded typical SD(delta C-13(pdb)) = 0.4 parts per thousand for fast GC and 0.5%o for conventional GC. For 14 of the 15 FAME, delta C-13 values between the two systems were within 1.5 parts per thousand and not significantly different Fast GCC-IRMS required one-third the run time (450 s vs 1400 s) to achieve comparable resolution. Mean peak widths for fast GCC-IRMS of the FAME were 720 ins, compared to 650 ms by fast GC with flame ionization detection. At a 15-fold dilution (100 pmol C on column for each FAME), fast GCC-IRMS achieved -2-fold better precision and accuracy than similar injections on conventional GCC-ERMS. Finally, a mixture of 10 steroids (similar to 7 nmol C (100 ng) each on column) was analyzed with mean precision of SD)(delta C-13) = 0.2 parts per thousand in 620 s by fast GCC-IRMS, while conventional GCC-IRMS required 1200 s and achieved poorer resolution. delta C-13 values for the two system were similar (Delta delta C-13 <=:5 2 parts per thousand for all steroids), indicating that accuracy is not compromised. In summary, fast GCC-IRMS can achieve similar precision to conventional GC with considerable time savings for standard sample sizes (> 1 nmol C) and achieves modest precision (similar to 1 parts per thousand) near the counting statistics limit on low level components.

Multireflecting gas chromatography‐multireflecting time‐of‐flight mass spectrometer with high dynamic range

A Perspective of Multi‐Reflecting TOF MS

Total-transfer comprehensive three-dimensional gas chromatography with time-of-flight mass spectrometry

Time-of-flight mass spectrometry (concepts, achievements, and prospects)

Fast gas chromatography combustion isotope ratio mass spectrometry.

Time-of-flight mass spectrometry with an electrospray ion beam

A high resolution and high sensitivity proton-transfer-reaction time-of-flight mass spectrometer (PTR-TOF-MS)

Direct sampling time-of-flight mass spectrometers for technological analysis

An automated gas chromatography time-of-flight mass spectrometry instrument for the quantitative analysis of halocarbons in air

Ultrafast Gas Chromatography-Tandem Differential Mobility Spectrometry: Toward A New Generation of On-Site, Real-Time Trace-Explosives Detection

Material Characterization Using a Tandem Micro-Reactor – GC–MS

High Mass Resolution Multireflection Time-of-Flight Secondary Ion Mass Spectrometer

A hyper-fast gas chromatograph coupled to an ion mobility spectrometer with high repetition rate and flow-optimized ion source to resolve the short chromatographic peaks

Evaluation of time-of-flight mass spectrometric detection for fast gas chromatography

Parallel coupling of gas chromatography to mass spectrometry and solid deposition Fourier transform infrared spectroscopy: an innovative approach to address challenging identifications

The OrbiTOF Mass Analyzer: Time-of-Flight Analysis via an Orbitrap Quadro-Logarithmic Field with Periodic Drift Focusing.

Analytical Performance of a Microsecond-pulse Glow Discharge Time of Flight Mass Spectrometer.

A Multi-Reflection Time-of-Flight Analyzer with a Long Focus Lens

High-Resolution Electrospray Ionization Orthogonal-Injection Time-of-Flight Mass Spectrometer

Microsecond Pulsed Glow Discharge Time‐of‐flight Mass Spectrometer

Tandem mass spectrometry using continuous‐wave infrared multiphoton dissociation in an electrostatic linear ion trap