Abstract:We demonstrate a novel transmission color filter design that exploits both dielectric and plasmonic resonances to establish a highly color-selective device, reaching an experimental full-width at half-maximum (fwhm) that is only half that of previously demonstrated cost-effective color filter devices for the same peak transmission and better out-of-band rejection. The measured fwhm is only 25 nm, and the peak transmission reaches up to 53%. The filter uses the interference of Fabry-Pérot resonances and guided-mode resonances in two separated dielectric slabs to achieve this excellent fwhm while relying on propagating surface plasmon polaritons to achieve the excellent out-of-band rejection. A simulation study elucidates the nature of the optical modes in the device and their interference mechanisms and reveals the most important design considerations. Fabrication was done in a CMOS pilot line and is cost-effective, as it requires only two metal patterning steps. Fabrication imperfections are discussed, together with strategies to mitigate them. We show the correct mitigation of these imperfections leads to further performance gain, enabling a full-width at half-maximum down to 20 nm and a peak transmission beyond 60%. We believe this novel filter design is a powerful concept to improve the spectral resolution of color filters for cost-effective multispectral imaging. Beyond multispectral imaging, the design could be adapted for other applications that require on-chip spectral filtering in a thin form factor.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsphotonics.1c01983.Table with dimensions of optimized unit cell designs for different pitches; Transfer matrix method applied to separate SiN sections to isolate Fabry-Pérot resonances; Simulated and measured transmission spectra for the orthogonal polarization (electric field parallel with the grating lines); Simulated transmission spectra for nonzero angle of incidence; Refractive index and extinction coefficient extracted from ellipsometry measurement (PDF)This article has not yet been cited by other publications.

Highly efficient and angle-tolerant mid-infrared filter based on a cascaded etalon resonator.

Decorative near-infrared transmission filters featuring high-efficiency and angular-insensitivity employing 1D photonic crystals

Angle-insensitive Decorative NIR Transmission Filter

Engineering Waveguide-Cavity Resonant Side Coupling in A Dynamically Tunable Ultracompact Photonic Crystal Filter

Non-polarized and Ultra-Narrow Band Filter in MIR Based on Multilayer Metasurface

Near-infrared Narrow-Band Minus Filter Based on a Mie Magnetic Dipole Resonance

Suspended Microracetrack Resonator with Lateral Sub-wavelength-Grating Metamaterial Cladding for Mid-infrared Sensing Applications

Dual-band Optical Filter Based on a Single Microring Resonator Embedded with Nanoholes

Integrated Broadband Filter with Sharp Transition Edges Based on SiN and SiON Composite Waveguide Coupler

Narrowband and high-transmissivity guided-mode resonance filter in the visible range

Ultracompact, Reflection-Free and High-Efficiency Channel Drop Filters Based on Photonic Crystal Nanobeam Cavities

Ultra-narrowband polarization insensitive transmission filter using a coupled dielectric metal metasurface

Plasmonic Narrowband Filter Based on an Equilateral Triangular Resonator with a Silver Bar

Narrowband wide dynamic range tunable filter based on Fano resonant planar multilayered structure

Ultra-Narrowband High-Transmissivity Guided-Mode Resonance Filter Based on Dual Dielectric Film Structure and High Refractive Index Waveguide Layer

Highly Selective Color Filters Based on Hybrid Plasmonic–Dielectric Nanostructures

Highly efficient optical filter based on vertically coupled photonic crystal cavity and bus waveguide

Highly Efficient Acoustooptic Tunable Filter Based on Cladding Etched Single-Mode Fiber

Design of mid-infrared filter array based on plasmonic metal nanodiscs array and its application to on-chip spectrometer

Spectral Filter in Short-Wave Infrareds Based on a Metasurface on Silicon-on-insulator with Polarizing Bandpass

Design and Fabrication of an Integrated Dual-Channel Thin-Film Filter for the Mid-Infrared