Abstract:The power module is one of the main heating sources with non-uniform heat flux in high-power electrical servo systems used for flight vehicles. Faults in the power module are usually caused by a high or a non-uniform temperature. Given the environment of heat dissipation during flight, a regenerative cooling method is typically used, and the cooling system is designed as a microchannel heat sink with supercritical fuel. This is an effective means of solving thermal problems in the flight vehicles. However, because of the high heating power and non-uniform heat distribution of the power module, it is necessary to optimize its heat sink to restrict the high temperature rise and suppress the non-uniform distribution of temperature. In light of these considerations, a 3D numerical model of the microchannel heat sink of a power module with non-uniform heat flux was established in this study to examine the heat transfer and the thermal performance of the cooling channels. Based on the validation of the mesh and numerical method, the simulations of the flow distributions of the channels were performed to assess the thermal performance of the heat sink. It included investigating the effects of the inlet location of the manifold and its injection angle on the flow distribution in the channels, and the influences of the flow distribution and the operational parameters on the thermal performance of the heat sink. The results revealed that the Z30 configuration provided the best location and injection angle of the inlet to match the non-uniform heat flux of the power module. In this case, the values of Stanton number and buoyancy parameter of channel 4 yielded the minimum values of all channels owing to its higher flow rate and gradual rise in temperature. The deviation in the rate of mass flow Φ changed slightly corresponding to the various operational parameters, only the total heat flux would bring a bigger fluctuation. The tiny difference in temperatures among the observation areas on the substrate verified the positive influence of the flow distribution in matching the non-uniform heat flux.

Exploiting the flow maldistribution characteristics in parallel microchannel heat sinks of I, U, and Z configurations to tackle the nonuniform heat loads

Numerical Study on Performances of Mini-Channel Heat Sinks with Non-Uniform Inlets

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Selecting optimal parallel microchannel configurations for active hot spot mitigation of multicore microprocessors in real time

Effect of Inlet Flow Maldistribution on the Passage Arrangement Design of Multi-Stream Plate-Fin Heat Exchanger

Study on the uneven flow distribution and non-uniform heat transfer in microchannels

Numerical simulation on variable width multi-channels heat sinks with non-uniform heat source

Single-phase and Two-phase Flow and Heat Transfer in Microchannel Heat Sink with Various Manifold Arrangements

Insight into porous fin microchannel heat sinks with improved thermo-hydraulic performance

Numerical study on hydrothermal performance in a microchannel with gradient array of ribs and pin fins

Fluid flow and heat transfer characteristics of a microstructured microchannel heat sink under flow boiling condition

Micro Pin Fins with Topologically Optimized Configurations Enhance Flow Boiling Heat Transfer in Manifold Microchannel Heat Sinks

Flow thermohydraulic characterization of hierarchical-manifold microchannel heat sink with uniform flow distribution

Thermally smart characteristics of nanofluids in parallel microchannel systems to mitigate hot spots in MEMS

NUMERICAL STUDY OF THE EFFECT OF AREA OF MANIFOLD AND INLET/OUTLET FLOW ARRANGEMENT 0N FLOW DISTRIBUTION IN PARALLEL RECTANGULAR MICROCHANNEL COOLING SYSTEM

Numerical study of different micro-channel structures on fluid flow and heat transfer performance

Achieving ultra-high coefficient of performance of two-phase microchannel heat sink with uniform void fraction

Performance Improvement of Z-Type Manifold Microchannel Heat Sink with Novel Fin-Arrangements

Study on the efficient heat transfer mechanism of microchannel pin-fin arrays under low pumping power

Computational analysis of microchannel heat sinks with constant circular pin fins: Performance evaluation and optimization