Abstract:Phase change materials (PCMs) exploit their cyclic phase change (solidification and melting) to enable latent heat storage. While incorporating them in thermally activated building systems can potentially enhance energy savings and thermal comfort, they can introduce significant challenges to the building energy management system. This work first reports the result of small-scale side-by-side experiments on two thermally active cuboids with and without BioPCMs at different supply water and PCM melting temperatures, as well as irradiance levels. Next, a dynamic model is developed in TRNSYS v18.05 for a typical design of an office space under hot desert climate conditions. The model is then integrated into a multi-objective optimization routine using NSGA-II algorithms to identify the optimal characteristic cooling curves, melting temperatures, and PCM thicknesses that simultaneously minimize energy consumption and maximize the percentage of comfortable hours. The experimental observations of the PCM-integrated cuboid highlighted energy savings between 80.45 and 84.56 %, compared to the reference cuboid, at nearly the same levels of indoor temperatures. The PCM panels reduced the cooling capacity of the radiant floor but also dampened air temperature variations by up to 83.17 %. Besides, higher solar irradiance levels, encountered in desert areas, were found to enhance the cooling capacity by up to 46.8 %. The Pareto solutions highlighted the possibility of achieving acceptable unmet hours of 3.16 % using PCMs and without the need for an assisting air system, compared to 14.1 % without PCMs. Besides, at the same unmet hours of the reference system, the PCMs reduced the total energy consumption and the peak cooling power by 9.75 and 41.2 %, which translates into substantial operation and capital investments, respectively. Moreover, the study demonstrated by example the importance of calibrating the commonly used cooling curves of thermally active buildings when planning for PCM integration.

Numerical simulation of composite PCM integration in prefabricated houses: Sustainable and improved energy design

Adjustable Insulation for Enhancing the Performance of Phase Change Materials in Buildings

Energy saving performance optimization and regional adaptability of prefabricated buildings with PCM in different climates

Numerical study on thermal comfort and energy-saving potential of a prefabricated temporary house integrated with composite phase change materials

Study on the Influence of the Application of Phase Change Material on Residential Energy Consumption in Cold Regions of China

Effect of melting point on thermodynamics of thin PCM reinforced residential frame walls in different climate zones

Parametric and economic analysis of incorporating phase change material (PCM) into exterior walls to reduce energy demand for traditional dwellings in northeast of Sichuan hills, China

Numerical analysis of PCM integrated year-round thermal energy savings building for composite climatic conditions

Analytical Optimization of Interior PCM for Energy Storage in a Lightweight Passive Solar Room

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Enhancing Energy Efficiency in Buildings through PCM Integration: A Study across Different Climatic Regions

Evaluating the potential of optimized PCM-wallboards for reducing energy consumption and CO 2 emission in buildings

Simulation-based optimization of PCM melting temperature to improve the energy performance in buildings

Thermal performance and economy of PCM foamed cement walls for buildings in different climate zones

Numerical simulations on the thermal performance of ventilated walls with passive solar heating and latent heat storage in winter

Numerical Study on the Effect of Incorporating Phase Change Materials in a Wall

Selection and testing of phase change materials in the physical models of buildings for heating and curing of construction elements made of precast concrete

Thermoeconomic analysis of a wall incorporating phase change material in a rural residence located in northeast China

Optimizing the characteristic cooling curves of PCM-integrated thermally active buildings: Experimental and numerical investigations

Simulation and designing of PCM wallboard rooms combined with night ventilation

Numerical analysis on the energy performance of the PCMs-integrated thermochromic coating building envelopes