Meeting the Challenges in Design and Execution of Two High Rate Acid Gas Injection Wells

Glen Benge,E. G. Dew,E.G. Dew

DOI: https://doi.org/10.2118/91861-ms

2005-02-23

Abstract:Abstract Two high rate acid gas injection wells were drilled in the LaBarge area of Wyoming. These wells were designed for injection of up to 65 million scf/day of a mixture of 65% H2S and 35% CO2. The primary engineering challenges in well design, casing selection, and cementing of the injection strings, along with the related operational challenges for both wells are discussed. Key drivers influencing zonal isolation, salt zone loading, casing and centralizer selection are presented. Casing selection was influenced by corrosive gas composition, high injection rates, and the potential for salt zone loading. The use of CRA tubulars, heavy wall casing for the salt loading, handling requirements, and centralizer selection are discussed. The primary driver in cement design was resistance to CO2, as past work has shown little H2S interaction with cement under these well conditions. A discussion of the development of a high alumina cement system with low fluid loss to address CO2 resistance and long liner length is coupled with the quality control steps taken from time of manufacture of the specialty cement to final placement in the well. Also described is the development of an alternate Portland cement system containing a reduced concentration of Portland cement by the use of sized particles to dilute the cement and reduce total system permeability. The unique engineering solutions resulted in operational challenges with casing running, cementing materials and equipment. A description of the location problems and the steps taken to resolve the issues are included. Introduction The acid gas injection wells were drilled as part of an overall gas plant de-bottlenecking. Plant throughput capacity was being increased by converting the plant to acid gas disposal by injection. The anticipated waste gas stream was 65% H2S and 35% CO2. Design volume for the wells was based upon the capacity of the plant plus adequate backup. The maximum planned plant waste capacity was 100 million standard cubic feet per day (MMscf/D), with the initial target waste volume planned at 65 MMscf/D per well. The corrosive gas stream required the use of specialty materials which complicated casing selection, centralizer selection and handling on location. Casing design was further challenged by the potential presence of a salt formation above the planned injection intervals. Unique cementing solutions are required in a CO2 environment. The gas converts calcium silicates in Portland cement to calcium carbonate, causing the cement to have an increased permeability and the system would be soluble in acid.1–5 CO2 flood projects typically require routine acidizing to remove scale caused by water in the gas stream. The acid could dissolve the converted cement sheath, and ultimately cause loss of containment in the annulus. The subject wells are not part of a CO2 flood, nor does the gas stream contain water, but CO2 resistance was considered integral to the design. Formation Considerations The primary zone for injection is the Madison formation (Mississippian system in the Paleozoic). The Madison is a massive carbonate composed of anhydrite and dolomite sequences within a limestone structure. This is the same formation from which the gas is produced but located far down dip. Injection is expected to be primarily into the dolomites where secondary permeability has been enhanced by the dolomitization process. Some injection would also be possible into the naturally fractured and vuggy limestones. The well designs would allow injection into all regulatory permitted intervals. Overlying and sealing the potential injection intervals is the Thaynes formation (Middle Triassic in the Mesozoic). In the producing field, the Thaynes contains thick layers of movable salt, where temperature and overburden are adequate to allow the formation to flow. In the producing field, production casing has collapsed across the salt.