Identification of Wells With High CO2-Leakage Potential in Mature Oil Fields Developed for CO2-Enhanced Oil Recovery

T. L. Watson,S. Bachu,Theresa Lucy Watson,Stefan Bachu

DOI: https://doi.org/10.2118/112924-ms

2008-04-20

Abstract:Abstract Previous work, presented in SPE 106817, "Evaluation of the Potential for Gas and CO2 Leakage along Wellbores", described a method to predict the potential for wellbore leakage which primarily occurs in the shallow areas of a wellbore. The work presented here focuses on the potential for leakage to occur from the deep regions of a wellbore, particularly from viable oil reservoirs. The potential for wellbore leakage where CO2 enhanced oil recovery (EOR) or sequestration is or may be conducted is specifically investigated. The Alberta Energy Resources Conservation Board collects and maintains data regarding cement types used in primary cementing of casing strings, stimulation information and abandonment data. These data were used to determine the potential for deep wellbore leakage in the presence of CO2. This deep wellbore leakage potential is then coupled with shallow wellbore leakage potential to predict which wells may leak to other reservoirs, potable groundwater aquifers or to the atmosphere in a CO2 sequestration or EOR project. Cements with additives such as bentonite have been shown to be particularly susceptible to CO2 attack. Wells were screened for cement blends placed in the deeper sections of the wellbore during primary cementing. This information is useful in predicting if a wellbore will remain leak free if CO2 is placed in the reservoir and the wellbore is contacted. The stimulation method was evaluated to determine if injected CO2 may break through to existing wellbores prior to full reservoir sweep, thus decreasing the time that the wellbore could remain leak free. Stimulations such as hydraulic fracture, perforating and acidizing with pressure were deemed to increase the likelihood that wellbores would leak due to cement sheath cracking coupled with CO2 attack of cement and casing. The abandonment method was also evaluated. In Alberta the primary form of zonal abandonment utilizes a mechanical bridge plug capped with cement. The bridge plug material is expected to fail in the presence of CO2 due to CO2 attack on elastomers and cast iron. Two large field evaluations are presented as case studies. Introduction Several client studies have been conducted to date in Alberta, Canada, to determine factors which may affect wellbore leakage. The findings of these studies were presented previously (Bachu and Watson, 2006; Watson and Bachu, 2007). These papers, particularly SPE 106817, presented an analysis of the factors that affect the leakage potential in the shallow part of a well, and a decision-tree type model which enables ranking of a well's potential to leak based on factors determined in the client studies. The original ranking system generally focused on leaks from the shallower regions of the well (Figure 1). These leaks typically manifest themselves at surface as annular pressure (surface casing vent flow-SCVF, known also as sustained casing pressure) or soil gas migration. This ranking system did not take into account the potential for a native or injected fluid or gas to create or increase the potential for a well to leak.