Preparation, characterization of co-Ni co-doped titania photocatalyst and its application for the photocatalytic degradation of textile and PPCPs industrial wastewater under sunlight
Asima Siddiqa,Sabtain Haider,Saba Saleem,Nisar Ahmad,Srosh Fazil,Asima SiddiqaSabtain HaiderSaba SaleemNisar AhmadSrosh Fazila Nanosciences and Technology Department,National Centre for Physics,Islamabad,Pakistanb Department of Chemistry,Quaid-i-Azam University,Islamabad,Pakistanc Department of Chemistry,University of Poonch Rawalakot,Azad Kashmir,Pakistan
DOI: https://doi.org/10.1080/00986445.2024.2321455
2024-02-28
Chemical Engineering Communications
Abstract:The undoped TiO 2 (T), 1% Ni-doped TiO 2 (N 1 T), and 1% Co–1% Ni co-doped TiO 2 (C 1 N 1 T) photocatalysts were prepared by the sol–gel technique. The characterization of prepared materials was carried out by X-ray diffraction, Diffused Reflectance Spectroscopy, Scanning Electron Microscopy, Fourier Transform Infrared Spectroscopy, Brunauer–Emmett–Teller and Thermogravimetric Analysis to analyze composition, phase, morphology, and optical properties. These results revealed that C 1 N 1 T exhibited higher surface area, better pore volume and enhanced optical properties as compared to undoped and Ni-doped TiO 2 . Furthermore, the photoactivity of C 1 N 1 T nanoparticles was manifested toward Acetaminophen, Phenol and reactive dyes i.e., Remazol Black B and Yellow 2 G. Moreover, C 1 N 1 T nanoparticles showed remarkable degradation efficiency of 53%, 56%, 98% and 89% for Acetaminophen, Phenol and anionic dyes, i.e. Remazol Black B and Yellow 2 G under optimized conditions (pollutant concentration = 20 ppm; time = 120 min; C 1 N 1 T loading = 20 mg; irradiation source = solar light; pH = 4 for each dye, pH = 7 for phenol and pH = 9 for acetaminophen). The significant degradation values suggested that the C 1 N 1 T photocatalyst can be effectively employed to degrade the textile dyes and PPCPs from industrial wastewater.
engineering, chemical