Surface integrity and fatigue behavior of AISI 4340 steel after hybrid laser-ultrasonic assisted ball burnishing process

Alireza Khodabandeh,Daniyal Sayadi,Sajjad Rajabi,Mohammadreza Khosrojerdi,Mohsen Khajehzadeh,Mohammad Reza Razfar

DOI: https://doi.org/10.1177/09544062241232236

2024-02-23

Proceedings of the Institution of Mechanical Engineers Part C Journal of Mechanical Engineering Science

Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. The final surface modification processes enhance the fatigue strength, wear resistance, and corrosion resistance of the workpiece by improving the surface quality, enhancing the microhardness, generating compressive residual stresses on the surface, and creating favorable changes in the microstructure. In this regard, using processes with different mechanisms is regarded as an optimal method to increase the efficiency of the final surface modification processes. This research seeks to experimentally investigate the hybrid laser-ultrasonic assisted ball burnishing (LUAB) process and its effect on the surface integrity and fatigue strength of 4340 alloy steel. The effect of the process on the sample's microstructure was evaluated by the images obtained from the optical microscope and SEM. Further, the parameters of mean surface roughness and microhardness, as well as the results of the uniaxial tensile test and fatigue test of the workpiece were evaluated. In the case of using appropriate parameters in the process, the results indicated a 93.38% reduction in mean surface roughness and an increase of surface microhardness by 3.4 times compared to the initial sample. Additionally, the investigation of microstructure revealed the accessibility of homogeneous and refinement martensitic structures without surface melting. The results of uniaxial tensile and fatigue tests indicated a 6.29% increase in tensile strength and a 20.71% increase in the endurance limit of the treated sample (LUAB) compared to the initial sample. Finally, the results also showed a change in the fracture mode in the uniaxial tensile test and a reduction in the final fracture area in the fatigue test.

engineering, mechanical