Role of Oxygen Vacancy Migration in Pyroelectric Currents of Nd 2 Ti 2 O 7 Ceramics as High Temperature Sensors

Manish Chandra Joshi,Lavadiya Sireesha,Sai Santosh Kumar Raavi,Ranjith Ramadurai
DOI: https://doi.org/10.1109/jsen.2024.3369327
IF: 4.3
2024-01-01
IEEE Sensors Journal
Abstract:A high TC ferroelectric material Nd2Ti2O7 (Neodymium Titanate) was studied using photocurrent measurement and impedance spectroscopy to investigate the intrinsic and extrinsic factors in the pyrocurrent generation. The alteration in the pyroelectric coefficient was observed while varying the heating and cooling rates, spanning from 5°C/min to 30°C/min, corresponding to values of 88-90 μC/m2K and 28-30 μC/m2K, respectively. At higher heating and cooling rates (30°C/min to 80°C/min), the pyroelectric coefficients remained relatively constant (21.8±4.0 μC/m2K). The dispersive nature of the pyrocurrent was verified through photocurrent studies followed by impedance spectroscopy analysis. The measurements outcomes reveal the presence of oxygen vacancies that dominate between 300°C and 500°C. Below 300°C, extrinsic factors such as shallow traps, consisting of space-charge near electrode-material interface, could have a greater impact on the pyrocurrent at zero electric field. When an electric field is applied above 300°C, oxygen vacancies migration can become the dominant conduction mechanism due to the collective effect of electric field and temperature. The estimated relaxation time (τ M′′) exhibits the Arrhenius behaviour, with an activation energy of ~ 0.92 eV, which implies oxygen vacancy migration with the assistance of external electric field. However, the thermal cycling of samples provided a true estimate of intrinsic pyroelectric currents in NTO ceramics without the influence of the thermal migration of oxygen vacancies resulting into a temperature-independent pyroelectric coefficient of about 15±0.5 μC/m2K in the temperature range of 300°C to 500°C. Thus, NTO ceramic can operate as a temperature sensor without influence of extrinsic factors for the temperature range of 300°C to 500°C.
engineering, electrical & electronic,instruments & instrumentation,physics, applied
What problem does this paper attempt to address?