Abstract:Dose evaluation and direct measurements are fundamental for radiation protection in non-conventional accelerator facilities, both before and after the primary and secondary shielding. In this paper, we will report about the experimental setup, data acquisition and analysis, together with FLUKA modeling, of the dose measurements test carried out in the Beam Test Facility (BTF) of the INFN - Frascati's National Laboratories (LNF), where an intense mixed field is produced and measured with thermoluminescent dosimeters. BTF is an extraction and transport line of DA Φ NE LINAC (Buonomo et al. 2021; Mazzitelli et al. 2003) . It is optimized for electrons and positrons production in a wide range of intensity, energy (30 MeV – 800 MeV), beam spot dimensions and divergence, using both primary and secondary beam of the DA Φ NE LINAC. Through the years, the BTF has gained an important role in particle detectors test and development with electron/positron beam. A small fraction of the BTF's shifts have been dedicated to radiation damage test using LINAC electron primary beam up to 5 x 1010 e-/s. As radiation protection group of the LNF, we evaluated the dose when electrons impinging on a Pb target from: i) photon Bremsstrahlung production; ii) photoneutron production. Three dedicated tests with 503 MeV electrons impinging on a ∼ 16 cm thick Pb target have been carried out in February, June 2022 and in January 2023, using TLD700 and TLD600, measuring doses at several charge intervals. The aim of this study focuses on evaluating dosimetric quantities produced by the mixed field, air kerma for the photon component, and ambient dose equivalent for the neutron one, using thermoluminescence dosimeters calibrated with low-energy standards: Cs-137 and Am-Be. The approach adopted involves the use of Monte Carlo simulations of the experiment, both to benchmark against experimental measurements and to validate the results obtained for energies higher than those of calibration. The results of this comparison show excellent agreement between measured and simulated quantities in the forward direction, allowing us to conclude and confirm the validity of the calibrations themselves.

Neutronic assessment of the IFMIF-DONES HFTM specimen stack distribution

Neutronic analysis of IFMIF-DONES test cell cooling system

Neutron availability in the Complementary Experiments Hall of the IFMIF-DONES facility

Neutronic Analysis of Ifmif High Flux Test Module for High Temperature Irradiation

Updates of the removable biological shielding blocks inside of the test cell, part of the test systems of IFMIF-DONES

Monitoring for Actinide Neutron Emissions From Spent Nuclear Fuel Under Extreme Gamma Fields Using Centrifugally Tensioned Metastable Fluid Detector Sensor Technology

Engineering design status of IFMIF-DONES High Energy Beam Transport line and Beam Dump system inside the TIR and RIZ

Status of the engineering design of the IFMIF-DONES high energy beam transport line and beam dump system

Consequences of Neutron Energy Spectrum on Radiation Damage, Gas Production, and Transmutations in Fusion Materials

Fluence and dose measurements for an accelerator neutron beam

Shielding optimization to reduce the radiation field in the accelerator systems of IFMIF-DONES

Photon and neutron dose evaluation at the beam test facility of the INFN - National laboratory of Frascati

The IFMIF-DONES project: preliminary engineering design

Production of 177Lu at the IFMIF-DONES Facility

Production of 177Lu with deuterons at IFMIF-DONES facility

Update of the 5 MW Beam-on-Target Requirements for improvement of the materials irradiation performance at IFMIF-DONES

High-Fluence Multi-Energy Ion Irradiation for Testing of Materials

Effects of HFIR neutron irradiation on fracture toughness properties of standard and Ni-doped F82H

Calculation and verification of neutron irradiation damage with differential cross sections

A Generic Implementation of the D1S Methodology for Dose Rate Assessment by Monte Carlo Codes in Fusion Applications

The In-situ Neutronics Calculation of NFM in the ITER