Abstract:It is common that steam turbine works at different operating points, especially under low load conditions, to cater to complex and varied demands for power generation recently. Considering the long and thin shape of last stage moving blades (LSMBs) in a low-pressure (LP) steam turbine, there are many challenges to design a suitable case which balances global efficiency against sufficient structure strength when suffering excitations at low load operating points. In present work, the aim is to extract specific aerodynamic excitations and recognize their distribution and propagation features. Firstly, steady 3D computational fluid dynamics (CFD) calculations are simulated at 25GV and 17GV (25% and 17% of design mass flow conditions) and corresponding unsteady calculations are performed with enough rotor revolutions to obtain integrated flow periodicities. Unsteady pressure signals near tip region of LSMBs are monitored circumferentially in both static and rotating coordinates. The fast Fourier transformation (FFT) results of unsteady pressure signals show that there are broadband humps with small disturbance amplitudes in low frequency spectrum at 25GV, however, a sharp spike is shown in low frequency spectrum at 17GV. Further, circumferential mode decomposition (CMD) method has been applied to distinguish different fluctuations in frequency and the mode numbers and circumferential propagating pace of which have been obtained. Finally, dynamic mode decomposition (DMD) method has been performed to describe detailed mode shapes of featured flow perturbances both in static and rotating coordinate system. These analyses indicate that at 25GV, a band of unsteady responses with very low amplitude was noted which has some features similar to rotating instability (RI). However, distribution and propagation features of flow unsteadiness at 17GV are in good agreement with rotating stall (RS) in compressor.

Numerical simulation of the relationship between steam flow excitation characteristics and coverage on the governing stage of marine steam turbine

Numerical Simulation of Unsteady Flow Phenomena and Exciting Force in Control Stage of Steam Turbine under Multiple Working Conditions

Numerical Simulation of Unsteady Flow Phenomena and Excitation Force in Control Stage of Steam Turbine

Rotor Dynamic Analysis On Partial Admission Control Stage In A Large Power Steam Turbine

Numerical Study on Three-Dimensional Flow in Control Stage of Steam Turbine under Multiple Working Conditions Considering Leakage Flows in Seals

Rotordynamic Stability under Partial Admission Conditions in A Large Power Steam Turbine

Numerical Analysis of Vibration Under Partial Admission of Steam Turbine

Numerical Study on Unsteady Flow of a Supersonic Partial Admission Impulse Turbine

Effects of the steam excitation force to the vibration behaviours of the turbomachinery

Full 3-D Unsteady Numerical Simulation of Control Stage in Partial Admission Turbine

Vibration Analysis of the Steam Turbine under Partial Admission

Numerical Simulation of Effect of Adjust Stage Local Intake on Aerodynamic Load of Downstream Rotor Blade

Experimental and Numerical Analysis of Pressure Pulses Characteristics in A Francis Turbine with Partial Load

Numerical Study On Three Dimensional Unsteady Flow Of A High Pressure Gas Turbine Stage

Numerical Investigations on the Aerodynamic Performance of Turbine Stage and Rotordynamic Characteristics of Stator Seal with Consideration of Supplementary Steam

Numerical Investigation on Flow Characteristics in Steam Turbine Low Pressure Cylinder and LPEH under Different Volume Flow Rate Conditions

Numerical Investigation on the Characteristics of the Guide Vane Stages in a Steam Turbine

Numerical Investigation on the Self-Excited Oscillation of Wet Steam Flow in A Supersonic Turbine Cascade

Aerodynamic Numerical Investigation Of Low-Pressure Steam Turbine Last Stage Under Low Load Conditions With Mode Decomposition Methods

Study of the Phase Resonance Phenomenon in Francis Turbine

Numerical Analysis of Unsteady Flow under High‐head Operating Conditions in Francis Turbine