Passive flow-field control using dimples for improved aerodynamic flow over a wing

Haris Ali,Mohammad Rasidi Rasani,Zambri Harun,Muhammad Ashhad Shahid
DOI: https://doi.org/10.1038/s41598-024-63638-z
IF: 4.6
2024-06-07
Scientific Reports
Abstract:This study explores the efficacy of dimples in influencing the aerodynamic performance of a straight rectangular wing. Computational Fluid Dynamics based numerical simulations were performed to model turbulent flow and quantify the forces exerted on the wing. The k-ω Shear-Stress Transport turbulence model was chosen to solve the underlying equations. To ascertain reliability, the results of numerical simulations were compared with both experimental and simulation results of the previous studies. The impact of various dimple configurations, placed at 15%, 50% and 85% of the chord length, on the aerodynamic performance of the wing was investigated. The evaluation involved analyzing the drag coefficient ( C D ), lift coefficient ( C L ), lift-to-drag ( L/D ) ratio, streamlines and the flow field around wing in both chordwise and spanwise directions. The findings indicated that a wing with a dimpled surface could yield a reduced drag coefficient of up to 6.6% compared to the unmodified wing. This reduction is attributed to the dimples ability to sustain attached airflow and delay flow separation. The results demonstrated negligible deviation in the lift coefficient with the incorporation of dimples. The incorporation of dimples on the wing surface has been demonstrated to enhance the aerodynamic performance of lifting surfaces.
multidisciplinary sciences
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to improve the aerodynamic performance of the wing by adding dimples on the wing surface. Specifically, the research aims to evaluate the effects of different dimple configurations on the drag coefficient ($C_D$), lift coefficient ($C_L$) and lift - to - drag ratio ($L/D$) of a straight rectangular wing, and explore how these dimples can improve the aerodynamic performance of the wing by delaying flow separation and reducing drag. ### Research Background - **Economic and Environmental Considerations**: Reducing the drag caused by fluid motion is not only for optimizing the interaction with turbulence, but also an important technical challenge with broad application prospects. Especially in the aerospace field, the drag generated by aircraft is one of the main obstacles affecting their performance. Reducing drag can save fuel and make flight more efficient and economical. - **Passive Flow Control**: Although active flow control methods are highly adaptable, they are costly and require additional energy supply. In contrast, passive flow control methods are simpler and more economical, achieved by adding structures or slightly modifying the geometry on the object surface. Among them, using dimples is a new method that is easy to manufacture and does not require sharp details. ### Research Methods - **CFD Simulation**: The computational fluid dynamics (CFD) method is used for numerical simulation, and the k - ω SST turbulence model is used to solve the control equations. - **Experimental Verification**: The numerical simulation results are compared with previous experimental and simulation results to verify the reliability of the model. - **Dimple Configurations**: The effects of three dimple configurations at different positions (15%, 50% and 85% chord lengths) on the aerodynamic performance of the wing are studied. ### Main Findings - **Drag Coefficient**: The drag coefficient of the wing with dimples can be reduced by up to 6.6%, which is attributed to the ability of the dimples to maintain attached flow and delay flow separation. - **Lift Coefficient**: The introduction of dimples has a relatively small impact on the lift coefficient, indicating that this improvement will not significantly change the structural characteristics of the wing. - **Lift - to - Drag Ratio**: The lift - to - drag ratio of configuration 1 (C1 - IDSS, dimples on the suction surface) is increased by 9.29% at all angles of attack. ### Conclusion By appropriately designing and implementing dimples on the wing surface, the aerodynamic performance of the wing can be effectively improved, especially under low subsonic conditions. This research provides a valuable reference for future applications in the aerospace field.