Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

Partial Discharge characteristics of mineral oil using needle — Plane and needle — Sphere electrode configuration base on pulse current measurement

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial Discharge Characteristics of Needle-plate Electrodes in Aging Oil-paper Insulation Under Combined AC-DC Voltage

Partial Discharge Characteristics over Differently Aged Oil/pressboard Interfaces

Measurement and Simulation of Partial Discharge in Oil-Paper Insulation under the Combined AC–DC Voltage

Partial Discharge of Needle-Plane Defect in Oil-Paper Insulation under AC and DC Combined Voltages: Developing Processes and Characteristics

PD Pulse Waveform and Charge Distribution in Oil-Pressboard Insulation with Needle-Plate Model at Positive DC Voltage: Their Characteristics and Relationship

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Partial Discharge Current Pulse Characteristics of Needle-Plate Electrode Based on the High Bandwidth Measurement Method

Design of Double Needles Defect Model in Oil Immersed Inverted Current Transformer and Its Partial Discharge Characteristic

Primary Differential Pulse Method for Partial-Discharge Detection of Oil-Immersed Inverted Current Transformers

Partial Discharge Characteristics Of Palm Fatty Acid Ester For Dissolved Gas Analysis

Characteristics of Partial Discharge in Oil-paper Insulated Needle Plate Electrode Model Under Composite AC-DC Voltage

PD Characteristics in Transformer Oil under AC Condition

Correlation Between Dielectric Loss and Partial Discharge of Oil-Pressboard Insulation

Measurement and Analysis for Pulse Current Shapes of Partial Discharge in Oil under DC Voltage

Partial-Discharge Characteristics of Free Spherical Conducting Particles under AC Condition in Transformer Oils

Electro–acoustic Transition of Partial Discharge in Insulating Oil: from the Correlation of Acoustic Wave and Discharge Energy

Comparative Research on Current Pulse Method and UHF Measurements of Partial Discharge in Mineral Oil

Measurement And Mathematical Fitting Of Partial Discharge Pulse Burst In Transformer Oils

Partition and Recognition of Partial Discharge Development Stages in Oil-Pressboard Insulation with Needle-Plate Electrodes under Combined AC-DC Voltage Stress