Abstract:Background: A synthetic peptide (P-15) analog of collagen added to anorganic bovine bone mineral (ABM) has recently been used as an enhanced bone graft material (ABM/P-15). The objective of this study was to test the contribution of ABM/P-15 in a new putty form (PEP) in two experimental membrane-protected defects: periodontal and intrabony. Its efficacy as filler biomaterial in guided tissue regeneration (GTR) and guided bone regeneration (GBR) procedures was evaluated histologically and morphometrically. Methods: In the maxillary canines, a facial mucoperiosteal flap was raised bilaterally in nine dogs. Two circular defects, 5 mm in diameter and 2 mm in depth, were made on each side: a fenestrated periodontal on the canine root and an intrabony in the alveolar diastema, anteriorly. PEP particles filled both defects on one side; the contralateral side was blood filled (control). All surgical sites were covered with a bioabsorbable membrane. Histologically, at 4 months, tissue blocks were made using the cutting/grinding non-decalcification method followed by morphometric analysis. In the periodontal fenestration root surface, the linear percentage of new cementum (%CEM), area percentage of new bone (%NB), and residual biomaterial particles (%PEP) were calculated. These same measurements were calculated at the intrabony sites, except cementum. The amount of direct NB to PEP contact was measured to assess the osteoconductivity level (OSC). The Pearson correlation test was used to evaluate any significant relationship between the different measured parameters. Results: In the grafted and non-grafted fenestration root surface defects, %CEM averaged 59.5% and 73.9% (P <0.02), respectively; %NB averaged 36.1% and 31.4%, respectively; and %PEP averaged 20.6%. The mean percentage of OSC was 52.4%. In the intrabony grafted and non-grafted sites, %NB averaged 50.7% and 60.1%, respectively (P <0.02). Residual %PEP averaged 26.1%, and OSC averaged 35.6%. At the intrabony sites, higher %NB and lower %OSC were found compared to the fenestration sites (P <0.001 and P <0.03, respectively). Correlation analysis showed a negative correlation between %NB and %PEP at the fenestration defects. In between the two defect types, %OSC was significantly correlated (P <0.05). Conclusions: ABM/P-15 putty showed osteoconductive and biocompatible qualities. However, at 4 months in this model, no enhanced regeneration was present compared to a higher CEM and NB growth detected at non-grafted membrane-protected sites.

Efficacy of sintered Zinc-doped fluorapatite scaffold as an antimicrobial regenerative bone filler for dental applications

Sintered fluorapatite scaffolds as an autograft‐like engineered bone graft

Inclusion of calcium phosphate does not further improve in vitro and in vivo osteogenesis in a novel, highly biocompatible, mechanically stable and 3D printable polymer

Antimicrobial Properties and Cytotoxic Effect Evaluation of Nanosized Hydroxyapatite and Fluorapatite Dedicated for Alveolar Bone Regeneration

Effect of fluoride-substituted apatite on in vivo bone formation

Osteogenesis of Mineralized Collagen Bone Graft Modified by PLA and Calcium Sulfate Hemihydrate: in Vivo Study

Zinc and chitosan-enhanced β-tricalcium phosphate from calcined fetal bovine bone for mandible reconstruction

Preparation and in-vitro evaluation of Fe2O3-doped DP-bioglass in combination with 3D-printing and selective laser sintering process (3DP-SLS) for alveolar bone augmentation

The effectiveness of functionalized nano-hydroxyapatite filler on the physical and mechanical properties of novel dental restorative composite

Bone regeneration driven by a nano-hydroxyapatite/chitosan composite bioaerogel for periodontal regeneration

Structural Characterization and Osseointegrative Properties of Pulsed Laser-Deposited Fluorinated Hydroxyapatite Films on Nano-Zirconia for Implant Applications

Fish scale-derived hydroxyapatite for alveolar ridge preservation

Biotin-avidin Mediates the Binding of Adipose-Derived Stem Cells to a Porous Β-Tricalcium Phosphate Scaffold: Mandibular Regeneration

Evaluation of a bone filler scaffold for local antibiotic delivery to prevent Staphylococcus aureus infection in a contaminated bone defect

A Porous Fluoride-Substituted Bovine-Derived Hydroxyapatite Scaffold Constructed for Applications in Bone Tissue Regeneration

Improving cell proliferation using polylactic acid, polycaprolactone, hydroxyapatite and zinc oxide nanocomposite for cancellous bone substitutes

Experimental intrabony and periodontal defects treated with natural mineral combined with a synthetic cell-binding Peptide in the canine: morphometric evaluations

Personalized and Defect-Specific Antibiotic-Laden Scaffolds for Periodontal Infection Ablation

Evaluation of the Regenerative Capacity of Demineralized Bone Matrix vs Fat Graft in Alveolar Cleft Model in Albino Rats

Progress in Dentin-Derived Bone Graft Materials: A New Xenogeneic Dentin-Derived Material with Retained Organic Component Allows for Broader and Easier Application

A Composite Lactide-Mineral 3D-Printed Scaffold for Bone Repair and Regeneration