Abstract:Selective catalytic reduction (SCR) is a crucial technique for mitigating nitrogen oxides emission of internal combustion engines. Compared with vanadium-based catalysts, copper-based molecular sieve catalysts exhibit superior low-temperature catalytic performance and anti-aging properties. The catalytic characteristics of Cu-SSZ-13 catalyst in both fresh and aged states are investigated through experimental and numerical simulations. The catalytic performance of Cu-SSZ-13 catalyst with 200 g/L coating is investigated under wide inlet temperatures (180 °C–450 °C) and ANR (ammonia to nitrogen ratio) (1–1.4) conditions via an engine emission test device. Further, the apparatus is adopted to evaluate performance at various aging temperatures (600 °C, 700 °C, and 800 °C). The aging factor is introduced based on experimental results to establish and correct the kinetic model for SCR aging state. The results illuminate that the increase of ANR fails to compensate for decline of catalytic efficiency under low-temperature conditions (150 °C).The generated quantity of isocyanate acid through the side reaction of urea hydrolysis increases proportionally with ANR. And it increased supply only resulted in a marginal 1 %–3 % improvement of catalytic efficiency. As SV decreases from 60,000 h −1 to 35,000 h −1 , the catalyst efficiency increases from 22 % to 45 %, resulting in an elevation of reactant concentration and its gradient on the catalyst surface. This leads to accelerated reaction rates and enhanced diffusion effects. The catalytic efficiency can be significantly enhanced at low temperatures when NO 2 fraction in NOx falls within the range of 10 %–25 %. The sensitivity of SCR reactions to aging varies at low temperatures (<250 °C) due to the distinct reaction sites on catalyst for different types of SCR reactions. The NO 2 SCR reactions exhibit minimal susceptibility, while the rapid SCR reactions are significantly impeded. Moreover, it has been observed that the catalyst microstructure was completely deteriorated under hydrothermal aging test at 900 °C operating condition. In general, the low-temperature catalytic performance of Cu-SSZ-13 catalyst can be further optimized by pretreating inlet gas components and optimizing the catalyst structure.

Migration of Cu species in Cu/SAPO-34 during hydrothermal aging

Migration of Cu Species in Cu/SAPO-34 During Hydrothermal Aging

Evolution of Copper Species on Cu/SAPO-34 SCR Catalysts Upon Hydrothermal Aging

The Migration of Cu Species over Cu–SAPO-34 and Its Effect on NH3 Oxidation at High Temperature

Migration mechanism on Cu species in CHA-type catalyst for the selective catalytic reduction of NOx during hydrothermal treatment

Migration, Reactivity, and Sulfur Tolerance of Copper Species in SAPO-34 Zeolite Toward NOx Reduction with Ammonia

The influence of chemical poisoning, hydrothermal aging and their co-effects on Cu-SAPO-34 catalyst for NOx reduction by NH3-SCR

Boosting the Catalytic Performance of Cu-SAPO-34 in NOx Removal Via Hydrothermal Treatment.

Relationships between copper speciation and Bronsted acidity evolution over Cu-SSZ-13 during hydrothermal aging

Insights into the impact of lanthanum on hydrothermal-induced migration and transformation of copper species in Cu/SAPO-34 catalyst for NH3-SCR

Boosting the catalytic performance of Cu-SAPO-34 in NO removal via hydrothermal treatment

Location and Nature of Cu Species in Cu/SAPO-34 for Selective Catalytic Reduction of NO with NH3

Characterization of Commercial Cu-SSZ-13 and Cu-SAPO-34 Catalysts with Hydrothermal Treatment for NH3-SCR of NOx in Diesel Exhaust

Investigation of low-temperature hydrothermal stability of Cu-SAPO-34 for selective catalytic reduction of NOx with NH3

Experimental and numerical study of Cu-SSZ-13 SCR system for NOx reduction and hydrothermal aging under diesel exhaust conditions

Impact of Hydrothermal Aging on SO2 Poisoning over Cu-SSZ-13 Diesel Exhaust SCR Catalysts

Interface Induced by Hydrothermal Aging Boosts the Low-Temperature Activity of Cu-SSZ-13 for Selective Catalytic Reduction of NOx

Understanding the influence of hydrothermal treatment on NH3-SCR of NO activity over Cu -SSZ-16

Improved Hydrothermal Stability of Cu-Sapo-18 by Sm Modification in the Selective Catalytic Reduction of Nox with Nh3

The enhanced catalytic activity of Cu/SAPO-34 by ion exchange method for selective catalytic reduction of nitric oxide

Catalytic deactivation mechanism research over Cu/SAPO-34 catalysts for NH3-SCR (I): The impact of 950 °c hydrothermal aging time