Abstract:A modified hysteresis torque controller is introduced into the direct torque control scheme of a 5-phase open-end winding induction motor, aimed at enhancing steady-state performance by minimizing torque, flux ripple, and current total harmonic distortion (%THD) with the dual 5-leg inverter configuration. The proposed Direct Torque Control (DTC) strategy utilizes a common DC source for both converters without the need for a bulky isolation transformer, accomplished by nullifying common mode voltage in the dual inverter open-end winding configuration. This proposed technique employs 30 virtual voltage vectors (VVVs) generated from the dual inverter configuration, strategically categorized as small, large, and medium voltage vectors. These 30 VVVs are instrumental in forming a 7-level torque controller and a 3-level torque controller in the proposed DTC scheme. In contrast to the existing DTC method, which uses 20 virtual voltage vectors from a dual 5-leg inverter configuration and grapples with challenges like high current harmonic distortion, torque ripple, and flux ripple, the proposed control scheme introduces a new 7-level torque hysteresis controller. The outcome is reduced torque and flux ripple, along with minimized harmonic content across various speeds and loading conditions without disturbing the dynamics. Experimental hardware results are scrutinized, comparing the classical DTC with the proposed DTC schemes in open-end winding induction motors, aiming to know the superior qualities of the proposed control approach.

Virtual Vector Direct Torque Control for a Nine-Phase Induction Machine Drive System With Eight Active Voltage Vectors Emulating Virtual Voltage Vectors

A Sequential Direct Torque Control Scheme for Seven-Phase Induction Machines Based on Virtual Voltage Vectors

A Novel Sequential Direct Torque Control Scheme for Seven-phase Induction Motors

Direct Torque Control with Zero-Voltage Vector for a Permanent Magnet Synchronous Motor

Predictive Current Control for Seven-Phase Induction Motor Based on the Optimal Operating Time of Four-Dimensional Vector

Direct Torque Control for Induction Motors Based on Minimum Voltage Vector Error

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Virtual Vector based SVPWM-DTC for Five-Phase Two-Level VSI fed Induction Motor Drive

Minimization of torque ripple of direct-torque controlled induction machines by improved discrete space vector modulation

Research on Torque Ripple Minimization Strategy for Direct Torque Control of Induction Motors

Research on Direct Torque Control of Induction Machine Based on Torque Prediction

A NEW APPROACH TO DIRECT TORQUE CONTROL OF INDUCTION MACHINES

Non-sinusoidal Output Voltage for Multiphase Variable Speed Drives with Space Vector PWM

An Isolation Transformer-less Single DC Source fed Dual 5-leg Inverter Controlled 5-Phase Induction Motor with Modified Direct Torque Control

A New Intelligent Control Strategy of Combined Vector Control and Direct Torque Control for Dynamic Performance Improvement of Induction Motor Drive

Dual-Vector-Based Predictive Torque Control for Fault-Tolerant Inverter-Fed Induction Motor Drives With Adaptive Switching Instant

Fault-Tolerant Direct Torque Control of Five-Phase Permanent Magnet Synchronous Motor under Single Open-Phase Fault Based on Virtual Vectors

Variable-structure torque control of induction motors using space vector modulation

A new 48-sector space vector decomposition-based SVM-DTC for performance improvement in direct torque-controlled six-phase asymmetrical induction motor drive

Implementation of Direct Torque Control Scheme for Induction Machines with Variable Structure Controllers

Harmonic reduction of Direct Torque Control of six-phase induction motor