Automated Design Optimization And Experimental Validation For Intermediate Casing Duct Of Aeroengine
Yadong Wu,Bin Li,Jinfang Teng,Yunyong Chen,You Li,Hongtao Wang
DOI: https://doi.org/10.1115/GT2013-94137
2013-01-01
Abstract:In aeroengine, an s-shaped annular duct is used to connect the high pressure compressor spool to the upstream low pressure compressor. The intermediate casing duct is required because the compressors are designed with different mean radii. Shortening the length of intermediate casing duct is of important significance for improving the performance of aeroengines. Meanwhile, the struts guiding the flow are installed in the intermediate duct, the inlet flow of the duct is not even, and outlet flow requires sufficient uniformity to ensure good working conditions for the high pressure compressor. So the design and optimization of flow path of intermediate casing duct including struts have very important practical significance.This study builds up a system of numerical optimization 3D model based on genetic algorithm and Kriging agent model on the Matlab platform, which automatically couples pre-processing, solver and post-processing of Numeca CFD software. This tool optimizes the intermediate casing duct including struts and a best flow path profile is obtained under the given constrained conditions.The optimization method is validated through experimental investigation. Four kinds of intermediate casing ducts are test, including the original model, optimization model, as well as two models based on optimization model, respectively. The chord of the struts and the length of flow path are changed for the last two models. The internal flow characteristics and aerodynamic performance of four cases above are measured, and the effects of the geometry structure of flow paths and struts to the aerodynamic performance of the ducts are evaluated, and the results may bring some modifications to the optimization method to make it more perfect. Through the experimental and numerical study, two key factors affecting the design of intermediate duct are brought about, which is the midway offset. ratio and the maximum to the minimum area ratio of flow path along streamwise including struts. For the given intermediate. casing duct in this study, the midway offset ratio is about 0.41, and the maximum to the minimum area ratio of flow path along streamwise including struts should be small.