Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Study on the influence of coil configuration on electromagnetic characteristics of inductively coupled plasma superimposed frequency selective surface

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

A Novel Frequency Selective Surface Applied for EMI Suppression in Integrated Circuit Package

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

A Novel Angularly Stable Wide Passband Frequency Selective Surface

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

Broad bandwidth of thin composite radar absorbing structures embedded with frequency selective surfaces

A Wideband Transmission Frequency Selective Surface Rasorber

A Conformal Miniaturized Bandpass Frequency-Selective Surface With Stable Frequency Response for Radome Applications

Study on the Electromagnetic Properties of Frequency Selective Surface Absorber

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

A Bandpass Frequency Selective Surface With a Low Cross-Polarization Based on Cavities With a Hybrid Boundary

Design of Frequency-Selective Surfaces Radome for a Planar Slotted Waveguide Antenna

EM Design and Analysis of Frequency Selective Surface Based on Substrate-Integrated Waveguide Technology for Airborne Radome Application

A Thin and Broadband Tunable Radar Absorber Using Active Frequency Selective Surface

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

Design and Synthesis of Band-Pass Frequency Selective Surface With Wideband Rejection and Fast Roll-Off Characteristics for Radome Applications

Research Progress and Application Prospects of Active Frequency Selective Surfaces

A Tuneable Microwave Absorber Using AFSS

A Study on the Electromagnetic–Thermal Coupling Effect of Cross-Slot Frequency Selective Surface

Mechanical and electromagnetic behavior of fabricated hybrid composite sandwich radome with a new optimized frequency-selective surface