Abstract:The cementation of desert aeolian sand is a key method to control land desertification and dust storms, so an economical, green and durable process to reach the binding between sand grains needs to be searched. The method based on the microbially induced calcite precipitation (MICP) appeared in recent years as a promising process that proved its efficiency. The feasibility of the MICP technique to treat aeolian sand composed by low clay content, fine particles, low water content and characterized by weak permeability was demonstrated in the present paper. The effects of initial dry density, cementation number and curing time on the permeability and strength of MICP-treated aeolian sand were investigated using permeability tests and unconfined compressive strength (UCS) tests. The microstructure of aeolian sand was observed by scanning electron microscopy (SEM) tests and X-ray diffraction (XRD), aiming to reveal the solidification principle of MICP. The tests result indicated that when the initial dry density and the cementation number rose, the hydraulic conductivity of aeolian sand decreased while the mechanical strength given by UCS values improved. When the initial dry density was 1.65 g/cm 3 , the curing time was 3 h and the cementation number reached 20, the hydraulic conductivity and UCS reached 0.00151 cm/s and 1050.30 kPa, respectively. With increasing curing time, the hydraulic conductivity first decreased, followed by an increase, while the UCS exhibited an up and then a downtrend. Furthermore, the correlation between UCS values and the CaCO 3 content reached a high R 2 value equal to 0.912, which confirmed that the cementation occurred in sandy material and governed the soil strengthening. Indeed, the calcium carbonate crystals observed by SEM and XRD enhanced the friction between particles when they wrapped around the sand grains surface, while carbonates reduced the soil permeability when filling the pores and sticking the sand particles together. Finally, the theoretical and scientific knowledge brought by the present study should help in managing sand in desert areas.

Mechanism of developing early strength of Portland cement-desert sand system under radiation in desert conditions

A Substitute for Portland Cement: Experiments on Ecofriendly Reinforcement of Large-Scale Calcareous Sand by Microbial-Induced Carbonate Precipitation Spraying Method

Mechanical Performances of Concrete Produced with Desert Sand After Elevated Temperature

Effect of Desert Sand on the Mechanical Properties of Desert Sand Concrete (DSC) after Elevated Temperature

Experimental Investigation on the Strength and Microscopic Properties of Cement-Stabilized Aeolian Sand

Effects of Cement Dosage, Curing Time, and Water Dosage on the Strength of Cement-Stabilized Aeolian Sand Based on Macroscopic and Microscopic Tests

Desert silty sand modified by anionic PAM and ordinary portland cement: Microfabric reinforcement and durability

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Experimental Study on the Mechanical Behaviors of Aeolian Sand Treated by Microbially Induced Calcite Precipitation (MICP) and Basalt Fiber Reinforcement (BFR)

Study on the Strength and Hydration Behavior of Sulfate-Resistant Cement in High Geothermal Environment

Mechanical properties of aeolian sand cemented via microbially induced calcite precipitation (MICP)

Mechanism of long-term strength retrogression of silica-enriched Portland cement assessed by quantitative X-ray diffraction analysis

Long-term Properties of Aeolian Sand-magnesium Oxychloride Cement Composites and Its Engineering Application

Evaluating the Effect of Cement and ARG Fiber on the Mechanical and Microstructural Properties of Dune Sand

Analysis of Early-Age Hydration Behavior and Micro-Mechanism of Coral Sand Cement Mortar

Hydration and hardening of class G oilwell cement

The microstructure, phase transformation and sinterability of desert sand

Effect of Post-Fire Curing on Compressive Strength of Ultra-High Performance Concrete and Mortar

On the relation of setting and early-age strength development to porosity and hydration in cement-based materials

Desert Aeolian Sand Cementation Via Microbially Induced Carbonate Precipitation

Engineering Properties of MICP-Bonded Sandstones Used for Historical Masonry Building Restoration