Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

Fatigue crack propagation behavior of IN718 superalloy aged with temperature/stress coupled field

Microstructure and tensile properties of IN718 superalloy aged with temperature/stress coupled field

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Investigation of fatigue mesoscopic mechanical properties of a nickel-based superalloy by instrumented microindentation measurements

Computational Analysis of Fatigue Crack Propagation at Elevated Temperature for In718

INITIATION AND PROPAGATION BEHAVIOR OF A FATIGUE CRACK OF ALLOY 718

Very-High-Cycle-Fatigue Property of IN 718 Manufactured by Selective Laser Melting at Elevated Temperature: Microstructure-Related Failure Behavior and Life Prediction

The Mechanism of Creep during Crack Propagation of a Superalloy under Fatigue–Creep–Environment Interactions

Fracture Mechanisms Induced by Microporosity and Precipitates in Isothermal Fatigue of Polycrystalline Nickel Based Superalloy

Fatigue behavior and fracture characteristics of 718Plus nickel-based superalloy at high temperature

Investigation of Fatigue Small Crack Propagation Behavior in Superalloy FGH96 under Different Stress Ratios

Influence of orientation and temperature on the fatigue crack growth of a nickel-based directionally solidified superalloy

Effect of Overaging on Fatigue Crack Propagation and Stress Corrosion Cracking Behaviors of an Al-Zn-Mg-Cu Alloy Thick Plate

Analysis of Microporosity-Dependent Fatigue Crack Behavior in Alloy 718 by Using Synchronic Radiation X-Ray CT and FEM

The Numerical Simulation of Fatigue Crack Propagation in Inconel 718 Alloy at Different Temperatures

Multi-scale Study of Subsurface Fatigue Cracking Behavior of Laser-Powder Bed Fused Inconel 718 at Stress Ratios and Temperatures

Evaluation of the Influences of the Stress Ratio, Temperatures, and Local Microstructure on Small Fatigue Crack Propagation Behavior of the FGH96 Superalloy

Fatigue-creep Behaviors of Ni–Fe Based Superalloy under Various Testing Conditions

Thermo-mechanical fatigue crack growth in a nickel-based powder metallurgy superalloy

Investigation of Microstructural Evolution and Mechanical Properties for In-Service Nickel-Based Superalloy

Study on fatigue crack propagation behavior of 2050 Al Li alloy during non-isothermal aging