Abstract:Ternary alloys consisting primarily of uranium, plutonium, and zirconium (U-Pu-Zr) are among the leading candidate fuel systems considered for fast spectrum nuclear reactors. Despite historical operation data from the testing of U-Pu-Zr rods in the Experimental Breeder Reactor-II, considerable uncertainty about the evolution of phases and microstructure across the ternary composition space exists. Due to sluggish kinetics and other difficulties in handling metal actinide specimens, quantitative measurements of phase-transitions in U-Pu-Zr alloys remain sparse in scientific literature, with most investigators reporting either phase-transition temperatures or phase identification data, but not both from the same specimens. The purpose of this paper is to critically compare experimental and calculated phase transition data and correlate with the microstructure and phase characterization data of as-cast and annealed U-Pu-Zr alloys. Phase transition peaks were measured using differential scanning calorimetry in the subsolidus regions (723−948 K) of three ternary U-Pu-Zr alloys with the same zirconium concentration but various U/Pu ratios. Overlapping peaks were deconvoluted using a Frazier-Suzuki peak fitting algorithm, and the critical peak temperatures and enthalpies were calculated. In general, increasing concentrations of Pu were associated with enhanced thermal stability of the body-centered cubic γ phase upon both heating and cooling. Experimental phase transition temperatures in this study tended to agree well with the predictions of the established ternary phase diagrams and other reported phase transition temperatures in literature. Additionally, the TAF-ID thermodynamic database was used to calculate a U-Pu-40 at.% Zr pseudobinary diagram as well as ternary diagrams from 773 −973 K. The equilibrium phase transition temperatures tended to be considerably lower than measured peak temperatures upon both heating and cooling. Recommendations for improving the quality of data in future U-Pu-Zr characterization studies are also discussed.

Synthesis, Characterization and Dissolution behavior of Nitrides of U-Zr and U-Pu-Zr Metallic Alloy fuels for Aqueous Reprocessing

HYDROXYLAMINE DERIVATIVE IN PUREX PROCESS. VI. STUDY ON THE PARTITION OF URANIUM/NEPTUNIUM AND URANIUM/PLUTONIUM WITH N,N-DIETHYLHYDROXYLAMINE IN THE PURIFICATION CYCLE OF URANIUM CONTACTOR

Radiochemical and chemical characterization of fuel, salt, and deposit from the electrorefining of irradiated U-6 wt% Zr in hot cells

Assay of Zirconium and Americium in the Irradiated U-Zr Metal Alloy Fuel Slug

Development of a New Aqueous Process for Nuclear Fuel Reprocessing: Hot Tests on the Recovery of U and Pu from a Nitric Acid Solution of Spent LWR Fuel

Head-End Dissolution for UC Processes and UC-PuC Reactor Fuels

Development of an Advanced Ion Exchange Process for Reprocessing Spent Nuclear Fuels

Particle emission from irradiated VVER-1200 fuel with Am burnable absorber

Nitrate Conversion and Supercritical Fluid Extraction of Uo2-Ceo2 Solid Solution Prepared by an Electrolytic Reduction-Coprecipitation Method

Advanced Characterization-Informed Framework and Quantitative Insight to Irradiated Annular U-10Zr Metallic Fuels

Development of analytical method for zirconium determination in U–Pu–Zr alloy samples

Investigation of Plasma-Chemical Synthesis of Complex Oxide Compositions for Dispersed Uranium-Plutonium Mixed Fuel

U-Si and U-Si-Ai Dispersion Fuel Alloy Development for Research and Test Reactors

Performance Improvement Analysis of Boiling Water Reactors by Incorporation of Hydride Fuel

Determining the effects of U/Pu ratio on subsolidus phase transitions in U-Pu-Zr metallic fuel alloys

Progress and Discussion on Chemical Separation Technologies for Nuclear Fuel Reprocessing Developed Abroad

Enhanced steam oxidation resistance of uranium nitride nuclear fuel pellets

Co-processing of uranium and plutonium for sodium-cooled fast reactor fuel reprocessing by acid split method for plutonium partitioning without reductant

Purification of U from U-10Mo scrap generated during the fabrication of high performance research reactor fuel

Characterization of U–Nb–Zr dispersion fuel prepared by centrifugal atomization process

Simulation of uranium mononitride spent fuel: A thermodynamic approach