Abstract:The electromechanical co-simulation method was used to simulate and analyze the 6-DOF (degrees of freedom) positioning and micro-vibration isolation functions of the platform in order to analyze the working performances of a contactless positioning and vibration isolation platform which works at space microgravity environment. The working principle of the contactless positioning and vibration isolation platform was introduced. The exciting unit, position measuring unit and acceleration measuring unit of the platform were made up by contactless biaxial actuators, biaxial position sensitive detectors and uniaxial accelerometers according to space symmetry layout scheme. The controller of the platform was designed based on position and acceleration feedback. Then the mechanical system simulation model and the closed-loop control system simulation model based on position and acceleration feedback was established by ADAMS and MATLAB/Simulink, respectively, which together set up the electromechanical co-simulation model of the platform. The positioning and vibration isolation performances of the platform were simulated by the co-simulation model. Results show that the 6-DOF displacement and angular displacement control errors of the platform are less than 10 μm and 2×10−5 rad respectively under small range positioning mode. The suppression efficiencies of the platform for 6-DOF direct sinusoidal disturbances with frequency range of 0.01−1 Hz and 1−100 Hz are 39−73 dB and 19−73 dB, respectively. The relative displacements between the floater and the stator are less than 1 mm during vibration isolation control process under vibration isolation mode.

Active Vibration Isolation of a Maglev Inertially Stabilized Platform Based on an Improved Linear Extended State Observer

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Design of a Maglev Stewart Platform for the Microgravity Vibration Isolation

State Space Lqg-Based Active Microvibration Control Of Micro-Manufacturing Platform

Reduced-order Generalized Proportional Integral Observer Based Continuous Dynamic Sliding Mode Control for Magnetic Levitation System with Time-varying Disturbances

Active Vibration Isolation of a Micro-Manufacturing Platform Based on a Neural Network

System Integration and Control Design of a Maglev Platform for Space Vibration Isolation

Experimental study of active isolation control based on magnetic suspension isolator

Modeling and Control of a Six Degrees of Freedom Maglev Vibration Isolation System

Active Maglev Vibration Isolator System Based on Adaptive Sliding Mode Control

Vibration Suppression for Magnetically Levitated High-Speed Motors Based on Polarity Switching Tracking Filter and Disturbance Observer

A Six Degrees-of-Freedom Vibration Isolation Platform Supported by a Hexapod of Quasi-Zero-Stiffness Struts

Semi-active control of the electromagnetic negative stiffness mechanism in a double-layer vibration isolator

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Sensor-Fusion-Based Simultaneous Positioning and Vibration Suppression Method for a Three-Degrees-of-Freedom Isolator

Payload-agnostic Decoupling and Hybrid Vibration Isolation Control for a Maglev Platform with Redundant Actuation

A Low Frequency Permanent Magnet Passive Vibration Isolator

Control and experimental study of 6-DOF vibration isolation platform with magnetorheological damper

Vibration Isolation Optimized Design of Magnetic Suspended Pump

Research on Active Vibration Isolation System of Sonar Platform

Active Vibration Isolation Platform with Eight Pneumatic Actuators