Field dynamic balancing for active magnetic bearings supporting rigid rotor shaft based on extended state observer

Kexiang Li,Cong Peng,Zhiquan Deng,Wei Huang,Zhongming Zhang

DOI: https://doi.org/10.1016/j.ymssp.2021.107801

IF: 8.4

2021-09-01

Mechanical Systems and Signal Processing

Abstract:Field dynamic balancing is an effective method to correct the mass imbalance of the rotor shaft supported by active magnetic bearings (AMB). However, the traditional strategies are all sensitive to the closed-loop control system. This paper presents a novel disturbance-observer-based dynamic balancing strategy. Firstly, based on the accurate model of AMB-rotor system with imbalance vibration, the extended state observer (ESO) is designed to estimate the imbalance information and the stability condition of ESO is figured out in its discrete state. Then in order to reduce the bad effects derived from sensor runouts, a band-pass filter is designed to be cascaded after ESO. Through one round of trial weighting, the coefficient matrix is modified, with which the precise correction mass information can be obtained. The simulation and experimental results validate the effectiveness and superiority of the proposed strategy. After field dynamic balancing on a test rig, the synchronous fluctuation amplitudes of displacements and currents are both eliminated obviously, and the evaluation results of vibrations comply with ISO 14839-2 standard.

engineering, mechanical

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: in a rigid rotor - shaft system supported by active magnetic bearings (AMB), how to effectively perform on - site dynamic balancing to correct the mass imbalance of the rotor. Traditional strategies are very sensitive to closed - loop control systems, which limits their scope of application and effectiveness. Therefore, this paper proposes a new perturbation observer dynamic balancing strategy based on the extended state observer (ESO), aiming to reduce adverse effects such as sensor offset and improve the accuracy and stability of dynamic balancing.

Specifically, the main objectives of the paper include:
1. **Design of the extended state observer (ESO)**: Based on the accurate model of the AMB - rotor system, design the ESO to estimate imbalance information and determine the stability conditions of the ESO in the discrete state.
2. **Design of a band - pass filter**: In order to reduce the adverse effects caused by sensor offset, a band - pass filter is designed and used in cascade with the ESO.
3. **Modify the coefficient matrix through test weighting**: Modify the coefficient matrix through one - time test weighting to obtain accurate correction mass information.
4. **Verify the effectiveness and superiority of the method**: Through simulation and experimental results, verify the effectiveness and superiority of the proposed strategy in eliminating the synchronous fluctuation amplitude and conforming to the ISO 14839 - 2 standard.

Through these objectives, the paper aims to provide an on - site dynamic balancing method independent of the closed - loop control system, thereby improving the accuracy and reliability of dynamic balancing.