Abstract:The pursuit of enhancing the performance of silicon-based solar cells is pivotal for the progression of solar photovoltaics as the most potential renewable energy technologies. Despite the existence of sophisticated methods like diffusion and ion implantation for doping phosphorus into p-type silicon wafers in the semiconductor industry, there is a compelling need to research spin-on doping techniques, especially in the context of tandem devices, where fabricating the bottom cell demands meticulous control over conditions. The primary challenge with existing silicon cell fabrication methods lies in their complexity, cost, and environmental concerns. Thus, this research focuses on the optimization of parameters, such as, deposition of the spin on doping layer, emitter thickness (Xj), and dopant concentration (ND) to maximize solar cell efficiency. We utilized both fabrication and simulation techniques to delve into these factors. Employing silicon wafer thickness of 625 μm, the study explored the effects of altering the count of dopant layers through the spin-on dopant (SOD) technique in the device fabrication. Interestingly, the increase of the dopant layers from 1 to 4 enhances efficiency, whereby, further addition of 6 and 8 layers worsens both series and shunt resistances, affecting the solar cell performance. The peak efficiency of 11.75 % achieved in fabrication of 4 layers dopant. By using device simulation with wxAMPS to perform a combinatorial analysis of Xj and ND, we further identified the optimal conditions for an emitter to achieve peak performance. Altering Xj between 0.05 μm and 10 μm and adjusting ND from 1e+15 cm-3 to 9e+15 cm-3, we found that maximum efficiency of 14.18 % was attained for Xj = 1 μm and ND = 9e+15 cm-3. This research addresses a crucial knowledge gap, providing insights for creating more efficient, cost-effective, and flexible silicon solar cells, thereby enhancing their viability as a sustainable energy source.

Enhancing Si-nanowire solar cell performance through fabrication and annealing optimization

Effect of diffusion doping-induced defects on shunt resistance affecting Si-nanowire solar cell performance

FABRICATION OF SILICON NANOWIRE (SiNW) ARRAYS AND APPLICATION IN SOLAR CELL

Design and Fabrication of Silicon Nanowires Towards Efficient Solar Cells

Antireflection Properties and Solar Cell Application of Silicon Nanostructures

Substantial Improvement of Short Wavelength Response in n-SiNW/PEDOT:PSS Solar Cell

Performance limitation of Si Nanowire solar cells: Effects of nanowire length and surface defects

Morphology-Tunable Assembly of Periodically Aligned Si Nanowire and Radial Pn Junction Arrays for Solar Cell Applications

Performance of Silicon Nanowire Solar Cells with Phosphorus-Diffused Emitters

An effective way to simultaneous realization of excellent optical and electrical performance in large‐scale Si nano/microstructures

Improved Device Performance of Si-based Heterojunction Solar Cells by Using Phosphorus Doped Si Nanocrystals Embedded in SiC Host Matrix

Enhanced Device Performance of Si Nanowires/si Nanocrystals Heterojunction Solar Cells with Ultrathin Al2O3 Passivation

New Approaches To Improve The Performance Of Thin-Film Radial Junction Solar Cells Built Over Silicon Nanowire Arrays

On The Annealing-Induced Enhancement Of The Interface Properties Of Nio:Cu/Wet-Siox/N-Si Tunnelling Junction Solar Cells

Nanostructural Optimization Of Silicon/Pedot: Pss Hybrid Solar Cells For Performance Improvement

An experimental investigation of spin-on doping optimization for enhanced electrical characteristics in silicon homojunction solar cells: Proof of concept

Absorption Enhancement of Single Silicon Nanowire by Tailoring Rear Metallic Film for Photovoltaic Applications.

Silicon Nanowires Incorporated Efficient and Flexible PEDOT:PSS/Silicon Hybrid Solar Cells

Refined optoelectronic properties of silicon nanowires for improving photovoltaic properties of crystalline solar cells: a simulation study

Optimization of p-i-n GaAs/AlGaAs Heterojunction Nanowire Solar Cell for improved Optical and Electrical Properties

Fabrication and configuration development of silicon nitride sub-wavelength structures for solar cell application.