Abstract:This work presents an experimental study of an electrochemical regenerator for stripping CO 2 and recovering potassium hydroxide from potassium carbonate/bicarbonate streams. This regenerator is applicable in the regenerative step of an aqueous Direct Air Capture (DAC) process during which CO 2 is captured from air using potassium hydroxide. Experimental tests were conducted in a near zero-gap cell designed with nickel foam electrodes to show CO 2 stripping from carbon-loaded streams, investigating the effects of current, flowrate, and concentration of anolyte and catholyte, on the performance of the electrochemical regenerator in terms of the CO 2 stripping efficiency (CSE) and energy consumption (EC). Results from the tests show that about 90 percent of the CSE is achievable in this process with a mixture of 0.15 M potassium carbonate and 0.15 M potassium bicarbonate as the feed stream at potassium factor, kf, of ∼1, whereby decreasing the alkalinity to carbon ratio can further boost the CSE under the same current density. The study shows that increasing the potassium factor favors the CSE, while increasing the buffering factor has a negative impact on the CSE. Furthermore, for potassium factors below the "buffering threshold", the CSE is negligible. Results also show that the CSE is constant for varying applied current at constant potassium factor. In addition, the influence of supporting electrolyte (SEL) in the cathode chamber of the regenerator, on both the CSE and the voltage penalty is studied. The use of concentrated KOH in the cathode helps to reduce voltage penalty. However, it shows a detrimental effect on the CSE due to the uphill difference in K + concentration between the two chambers, compared to deionized water. Experimental results show energy consumption in the range of 250-500 kJ/mol-CO 2 as a lower range of energy penalty for the regenerator, with CO 2 purity more than 70 percent for a DAC process.

Electrochemical Stripping of CO 2 from Potassium-based Salts to Facilitate Direct Air Capture

Unveiling the Porosity Effect of Superbase Ionic Liquid-Modified Carbon Sorbents in CO 2 Capture from Air

Numerical Modeling and Comparative Analysis of Electrolysis and Electrodialysis Systems for Direct Air Capture

Kinetic research on ion exchange regeneration of quaternary ammonium-based CO 2 sorbent for direct air capture

Electrochemical regeneration of high-purity CO 2 from (bi)carbonates in a porous solid electrolyte reactor for efficient carbon capture

Electrolytic Regeneration of Decarbonising Potassium Carbonate Solution

Regeneration of direct air CO2 capture liquid via alternating electrocatalysis

Performance Enhancement of a Membrane Electrochemical Cell for CO 2 Capture

Simulation of Carbon Dioxide Direct Air Capture Plant Using Potassium Hydroxide Aqueous Solution: Energy Optimization and CO2 Purity Enhancement

Kinetic Research on Ion Exchange Regeneration of Quaternary Ammonium-Based CO2 Sorbent for Direct Air Capture

Aqueous Electrochemical Direct Air Capture Using Alizarin Red S

From Lab to Fab: Development and Deployment of Direct Air Capture of CO2

Assessment of the Potential of Electrochemical Steps in Direct Air Capture through Techno-Economic Analysis

Evaluation of potassium glycinate as a green solvent for direct air capture and modelling its performance in hollow fiber membrane contactors

Electrolytic Regeneration of Spent Caustic Soda from CO2 Capture Systems

Alkalinity Concentration Swing for Direct Air Capture of Carbon Dioxide

Retrieval of CO2 from a carbonate solution for its sequestration by a novel electrochemical decarbonizing and ingathering method

[Palliative biliodigestive anastomosis in non-resectable cancer of the head of the pancreas--with or without preventive gastroenterostomy?].

Direct CO2 Electroreduction from Carbonate

Sorbent Regeneration via Radio Frequency Assisted Dielectric Heating for Direct Air Capture of CO2

Study on Electrolytic Regeneration of Decarbonization Liquid by Potassium Alkali