Abstract:This work presents an experimental study of an electrochemical regenerator for stripping CO 2 and recovering potassium hydroxide from potassium carbonate/bicarbonate streams. This regenerator is applicable in the regenerative step of an aqueous Direct Air Capture (DAC) process during which CO 2 is captured from air using potassium hydroxide. Experimental tests were conducted in a near zero-gap cell designed with nickel foam electrodes to show CO 2 stripping from carbon-loaded streams, investigating the effects of current, flowrate, and concentration of anolyte and catholyte, on the performance of the electrochemical regenerator in terms of the CO 2 stripping efficiency (CSE) and energy consumption (EC). Results from the tests show that about 90 percent of the CSE is achievable in this process with a mixture of 0.15 M potassium carbonate and 0.15 M potassium bicarbonate as the feed stream at potassium factor, kf, of ∼1, whereby decreasing the alkalinity to carbon ratio can further boost the CSE under the same current density. The study shows that increasing the potassium factor favors the CSE, while increasing the buffering factor has a negative impact on the CSE. Furthermore, for potassium factors below the "buffering threshold", the CSE is negligible. Results also show that the CSE is constant for varying applied current at constant potassium factor. In addition, the influence of supporting electrolyte (SEL) in the cathode chamber of the regenerator, on both the CSE and the voltage penalty is studied. The use of concentrated KOH in the cathode helps to reduce voltage penalty. However, it shows a detrimental effect on the CSE due to the uphill difference in K + concentration between the two chambers, compared to deionized water. Experimental results show energy consumption in the range of 250-500 kJ/mol-CO 2 as a lower range of energy penalty for the regenerator, with CO 2 purity more than 70 percent for a DAC process.

Electrochemical regeneration of high-purity CO 2 from (bi)carbonates in a porous solid electrolyte reactor for efficient carbon capture

Efficient CO<sub>2</sub> capture by a novel deep eutectic solvent through facile, one-pot synthesis with low energy consumption and feasible regeneration

Electrolytic Regeneration of Spent Caustic Soda from CO2 Capture Systems

Porous Polymeric Electrodes for Electrochemical Carbon Dioxide Capture

Direct CO2 Electroreduction from Carbonate

Regeneration of direct air CO2 capture liquid via alternating electrocatalysis

Electrochemical Stripping of CO 2 from Potassium-based Salts to Facilitate Direct Air Capture

Electrowinning-coupled CO2 Capture with Energy-Efficient Absorbent Regeneration: Towards Practical Application

Electrochemical Regeneration of CO2 Absorbent in a Microreactor

Electrolytic Regeneration of Decarbonising Potassium Carbonate Solution

Reactive carbon capture using electrochemical reactors

Recovering carbon losses in CO2 electrolysis using a solid electrolyte reactor

Scalable and low-energy decoupled electrochemical CO2 capture

Retrieval of CO2 from a carbonate solution for its sequestration by a novel electrochemical decarbonizing and ingathering method

An Electrochemical CO 2 Capture Cell Enhanced by Biological Proton‐Carrier Assisted Water Splitting

Performance Enhancement of a Membrane Electrochemical Cell for CO 2 Capture

Regeneration of Na2Q in an Electrochemical CO2 Capture System

Catalytic regeneration of amine-based absorbents for CO 2 capture: The effect of acidic sites and accessibility

CO2 electroreduction to multicarbon products from carbonate capture liquid

A Solid-State Electrolyte Facilitates Acidic CO2 Electrolysis without Alkali Metal Cations by Regulating Proton Transport

Study on the Mechanism and Energy Consumption of CO2 Regeneration Process by Membrane Electrolysis