Abstract:Renewable source-derived carbon is found to be a green alternative catalyst to zeolite for the pyrolysis of plastics. However, only polyethylene (PE) catalytic pyrolysis over biomass-derived carbon has been extensively studied. In this work, carbon was produced from industrial organic solid waste using different activation agents, and their catalytic performance on the thermal degradation of typical polymers, namely PE, polypropylene (PP), polystyrene (PS), and polyethylene terephthalate (PET) were investigated. The degradation mechanisms and the roles of different active sites of the carbons are discussed. Steam failed to activate the carbon, which has a low specific surface area (6.7 m2/g). Chemical activation using H3PO4 and ZnCl2 produces carbons with higher specific surface area and more porosity. The pyrolysis characteristics of LDPE, PP, PS, and PET catalyzed by the carbons were studied using TGA and a fixed-bed reactor. The thermogravimetric results indicate that all three carbons reduce the pyrolysis temperature. The analysis of the products shows that the P- and Zn-involved acid sites on the AC-HP and AC-ZN change the reaction pathway of plastics and promote: (1) C-C cracking and aromatization of polyolefins; (2) the protonation of phenyl carbon of PS to yield higher benzene, toluene, and ethylbenzene; and (3) the decarboxylation of the terephthalic acid intermediate of PET, resulting in higher CO2 and benzene. In addition, the high-value chemicals, long-chain alkylbenzenes, were found in the liquids of AC-ZN and AC-HP. The long-chain alkylbenzenes are probably formed by acid-catalyzed alkylation of aromatic hydrocarbons. This study provides basic data for the development of a cheap catalyst for plastic pyrolysis.

Waste derived ash as catalysts for the pyrolysis-catalytic steam reforming of waste plastics for hydrogen-rich syngas production

Hydrogen/Syngas Production from Different Types of Waste Plastics Using a Sacrificial Tire Char Catalyst via Pyrolysis–Catalytic Steam Reforming

Formation mechanism of hydrogen production from catalytic pyrolysis of waste tires: A ReaxFF molecular dynamics and experimental study

Effect of spent fluid catalytic cracking (FCC) catalyst on syngas production from pyrolysis and CO2-assisted gasification of waste tires

Plastic and Waste Tire Pyrolysis Focused on Hydrogen Production—A Review

Enhancing light fuel production through catalytic pyrolysis of municipal mixed plastic waste over activated spent FCC catalyst

Waste tire derived char supported Ni‐Fe catalyst for catalytic thermochemical conversion of wet municipal solid waste

Study on pyrolysis characteristics, kinetics and thermodynamics of waste tires catalytic pyrolysis with low-cost catalysts

Catalyst-mediated pyrolysis of waste plastics: tuning yield, composition, and nature of pyrolysis oil

Pyrolysis-plasma/catalytic reforming of post-consumer waste plastics for hydrogen production

A Novelty Catalytic Reforming of Tire Pyrolysis Oil for Hydrogen-Rich Syngas

Hydrogen Production by Steam Reforming of Pyrolysis Oil from Waste Plastic over 3 wt.% Ni/Ce-Zr-Mg/Al2O3 Catalyst

Hydrogen Production by Pyrolysis–Nonthermal Plasma/Catalytic Reforming of Waste Plastic over Different Catalyst Support Materials

Degradation of Rubber Waste into Hydrogen Enriched Syngas Via Microwave-Induced Catalytic Pyrolysis

Catalytic pyrolysis of tire waste: Impacts of biochar catalyst on product evolution

Potential of tire pyrolysis char as tar-cracking catalyst in solid waste and biomass gasification

Pyrolysis-catalysis of different waste plastics over Fe/Al2O3 catalyst: High-value hydrogen, liquid fuels, carbon nanotubes and possible reaction mechanisms

A lab scale waste to energy conversion study for pyrolysis of plastic with and without catalyst: Engine emissions testing study

Chemical recycling of mixed plastic waste via catalytic pyrolysis

From Waste to Energy: Enhancing Fuel and Hydrogen Production through Pyrolysis and In-Line Reforming of Plastic Wastes

Catalytic Pyrolysis of Waste Plastics over Industrial Organic Solid-Waste-Derived Activated Carbon: Impacts of Activation Agents