Abstract:This paper presents a detailed numerical investigation of the influence of re-organized shock waves on the flow separation for a highly-loaded transonic compressor cascade. The boundary layer suction (BLS) was used to control the location and strength of shock waves, with the aspirated slot locating at 49% chord, where is just downstream of the impingement point of shock wave at the leading edge. The numerical simulation is based on NUMECA, a commercial software, where the cell-centered control volume approach with third-order spatial accuracy is used to solve the 3-D Reynolds-averaged Navier-Stokes equations under the Cartesian coordinate system. Several conclusions can be made through the observation of the numerical results. (1) Multiple shock waves in cascade passage leaded the velocity deficits of boundary layer on suction surface downstream of shock wave, resulting in seriously separated flow on the suction side of blade, especially when the front shock wave is much stronger than the rest of the shocks. (2) BLS with small mass flow rate can not effectively improve the boundary layer. When the impingement point of oblique shock wave coming from cascade leading edge is bled to downstream of the passage shock wave by BLS, the boundary layer flow is greatly improved. However, if the BLS mass flow rate exceeds a critical value (1.2%), the boundary layer downstream of shock wave would separate from suction surface. (3) At the blade mid-span, the aerodynamic performance of compressor blade is improved as BLS mass flow rate increases. The optimum BLS is about 1.2%. Compared with the baseline case, the BLS with flow rate of 1.2% increases the total pressure recovery coefficient by 12%, and decreases diffusion factor by 18% and deviation angle to 7° while keeping the pressure rise constant. (4) The three dimensional flow structure of the compressor cascade ranged from 25% span to 75% span was improved greatly with the 1.2% BLS flow rate. However it could not control the development of the corner boundary layer effectively.

Quasi-wall-resolved large eddy simulation of transitional flow in a transonic compressor rotor

Large Eddy Simulation and CDNS Investigation of T106C Low-Pressure Turbine

Les and Cdns Investigation of T106c Low Pressure Turbine

Investigation of Transitional Flow in a Transonic Compressor Rotor with Hub Leakage Using Large Eddy Simulation

Large-Eddy Simulation of Transitional Flows on a Compressor Blade

Performance of Unsteady Reynolds-Averaged Navier-Stokes and Hybrid Scale-Resolving Simulation Approaches in Simulating a Low-Speed Axial Compressor Rotor

Improved hybrid model for transitional separated flows over a rough compressor blade

Investigation of Vortex Structures Near Tip Region in a Transonic Axial Flow Compressor Rotor

Numerical Investigations into the Origin of Tip Unsteadiness in a Transonic Compressor

Investigation of the Flow Mechanism of a Highly Loaded Compressor Cascade with Upstream Wakes at the Low Reynolds Number Condition

Numerical Investigation on the Effects of Re-Organized Shock Waves on the Flow Separation for a Highly-Loaded Transonic Compressor Cascade

Numerical Simulation and Experimental Validation of Tip Leakage Vortex Breakdown under Large Clearance

Study on Unsteady Flow Characteristic in a Transonic Axial Compressor Rotor at Near Stall Condition

A wall-modeled large-eddy simulation of the unsteady flow in a water-jet pump based on the turbulent length scales

Hybrid RANS-LES Simulation of Rotor-Stator Interaction in a Compressor Stage Using Grid-Adaptive Simulation Method

Transition-based Constrained Large-Eddy Simulation Method with Application to an Ultrahigh-Lift Low-Pressure Turbine Cascade Flow

Numerical simulation of unsteady single-stage transonic axial compressor flow

Vortex Structure Topology Analysis of the Transonic Rotor 37 Based on Large Eddy Simulation

Transitional Flow on Turbomachine Blade Using Discontinuous Galerkin Method

Direct Numerical Simulation of Boundary Layer Transition Induced by Roughness Element in a Low Reynolds Number Compressor Blade

Numerical Simulation on Unsteady Flow Mechanism of a 1.5-Stage Axial Transonic Compressor